Important Safeguards - Russell Hobbs PERFORMANCE PRO Instrucciones

Read the instructions, keep them safe, pass them on if you pass the appliance on. Remove all packaging
before use.

IMPORTANT SAFEGUARDS

Follow basic safety precautions, including:
This appliance can be used by persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been supervised/
instructed and understand the hazards involved.
Children must not use or play with the appliance. Keep the appliance and cable
out of reach of children.
Always disconnect the appliance from the mains supply socket if it is left
unattended and before assembling, disassembling or cleaning.
To avoid injury, take care handling the blades, emptying, and cleaning.
Don't add hot liquid (over 40°C), as it may be ejected due to sudden steaming.
Misuse of the appliance may cause injury.
If the cable is damaged, it must be replaced by the manufacturer, its service
agent, or someone similarly qualified, to avoid hazard.
• Don't put the motor unit in liquid.
• Switch off and wait till the blades come to a stop before removing the lid from the jug, or removing
the jug from the motor unit.
• Don't put utensils into the jug while the appliance is plugged in.
• Don't use accessories or attachments other than those we supply.
• Don't use the appliance for any purpose other than those described in these instructions.
• Don't operate the appliance if it's damaged or malfunctions.
• This appliance is not suitable for grinding coffee beans.
PARTS
1. Control panel
2. Motor unit
3. Jug
BEFORE FIRST USE
• Remove any packing materials, stickers , etc.
• Put the motor unit on a dry, firm, level surface.
• Wash all removable parts as described under CARE AND CLEANING.
USING
1. Put the ingredients into the jug. Don't exceed 2/3 full.
2. Fit the lid onto the jug. Press down until it is properly sealed.
3. Fit the cap into the lid. Twist it clockwise to lock it in place.
4. Place the assembled jug onto the motor. The handle can be on any side (FIG A).
5. Press the on/off button to switch the blender to standby mode
Note: If no buttons are pressed within 60 seconds the unit will automatically power off.
Manual control
With the unit in standby mode, press button 1 to 5.
1.
2. 1 is the slowest speed and 5 is the fastest speed. The motor will run continuously until you press the
Y / 2 button.
Alternatively, press the Y / 2 button in short bursts until the desired consistency is obtained.
HOUSEHOLD USE ONLY
4. Lid
5. Cap
` Dishwasher safe
3