Lawn-Boy 89906 Instrucciones De Instalación página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Figure 9
17. Position the rear bag handles into the bag hanger on
the handle.
18. Grasp the bag assembly handle and slide it over the
flange of the grass chute (Fig. 10). Push downward on
the handle until it seats into position.
Figure 10
19. Connect the wire to the spark plug.
Bag Adjustment
When you change the handle height, you may need to
adjust the bag. A properly adjusted bag should be taut on
the top cloth area between the front bag handle and the
rear bag hanger handles. If the bag is too tight or too
loose, adjust the bag as follows:
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug.
3. Remove the bag from the rear bag hanger. Remove the
bolt(s) and the knob(s) that secure the hanger clamps
to the handle sections (Fig. 11). The hanger clamps
have four adjustment holes.
1012
1. Knob
2. Bolt
4. Assemble the hanger clamps to the handle sections
using the set of holes that best holds the bag taut.
Using the lower holes in the hanger clamps tightens
the bag assembly; using the upper holes in the hanger
clamps loosens the bag assembly.
Note: Under normal use, the bag can wear and deteriorate.
Check the grass bag often and replace it when necessary
with a Lawn-Boy replacement bag. A weakened or
inferior bag may let objects pass through, causing injury.
1010
POTENTIAL HAZARD
Keep hands, sticks, or other objects out of the
grass chute while the blade is turning.
WHAT CAN HAPPEN
Thrown objects or contact with the blade can
cause serious injury.
HOW TO AVOID THE HAZARD
Always stop the engine when you empty the
grass bag. Disconnect the wire from the spark
plug before cleaning a clogged chute, the bag
tunnel, or the underside of the mower housing.
5. Connect the wire to the spark plug.
4
4
2
3
1
Figure 11
3. Hanger clamp
4. Bag hanger
WARNING
1011

Publicidad

Tabla de contenido
loading

Tabla de contenido