Philips Performer FC9177/01 Manual De Instrucciones página 10

English
10
Super Clean Air HEPA 12 filter/Ultra Clean Air HEPA 13 filter
This appliance is equipped with either the Super Clean Air HEPA 12 filter or the Ultra Clean Air
HEPA 13 filter. These filters are located in the back of the appliance. They are able to remove 99.5%
and 99.95% respectively of all particles down to 0.0003mm in size from the outlet air. This not only
includes normal house dust, but also harmful microscopic vermin such as dust mites and their
excrements, which are well-known causes of respiratory allergies.
Note: To guarantee optimal dust retention and performance of the vacuum cleaner, always replace the
HEPA filter with an original Philips filter of the correct type (see chapter 'Ordering accessories').
Super Clean Air HEPA 12 filter
Replace the Super Clean Air HEPA 12 filter every six months. This filter is not washable.
1 Open the filter grille (Fig. 28).
 Remove the old filter (Fig. 29).
 Insert the new filter into the appliance.
 Close the filter grille and push the bottom corners until they snap home (Fig. 30).
Washable Ultra Clean Air HEPA 13 filter
Clean the washable Ultra Clean Air HEPA 13 filter every 6 months. You can clean the washable
Ultra Clean Air HEPA 13 filter max. 4 times. Replace the filter after it has been cleaned 4 times.
1 Open the filter grille (Fig. 28).
 Take out the washable HEPA 13 filter (Fig. 29).
 Rinse the pleated side of the HEPA 13 filter under a hot slow-running tap.
- Hold the filter in such a way that the pleated side points upwards and the water flows parallel
to the pleats. Hold the filter at an angle so that the water washes away the dirt inside the
pleats (Fig. 31).
- Turn the filter 180° and let the water flow along the pleats in opposite direction (Fig. 32).
- Continue this process until the filter is clean.
Never clean the washable filter with a brush (Fig. 33).
Note: Cleaning does not restore the original colour of the filter, but does restore its filtration power.
 Carefully shake the water from the surface of the filter. Let the filter dry at least 2 hours
before you put it back into the vacuum cleaner.
5 Put the filter back into the appliance. Close the filter grille and push the bottom corners until
they snap home (Fig. 30).
storage
1 Slide the tube parts into each other to reduce the tube to its shortest length.
 Switch off the appliance and remove the mains plug from the wall socket.
 Press the cord rewind button to rewind the mains cord (Fig. 34).
 To store the appliance in upright position, insert the ridge on the nozzle into the storage
slot (Fig. 35).
5 Always put the Tri-Active nozzle in the carpet setting when you store it (brush strip
retracted into the nozzle). Also prevent the side brushes from becoming bent (Fig. 8).