Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
DRC8335_EN(verB)
7/23/07
Watching TV programs
Watching TV programs
In order to use the features of the unit, you will have to get
used to turning on the unit to watch TV.
1. Turn on your TV set and unit. After a few seconds
the main menu of the unit appears on the television
screen.
2. The "Live signal" function is already highlighted. Press
OK to tune to the last channel watched.
•
To display information on the current channel, press
INFO.
3. To change channel:
•
On the remote control – press CH+/CH– or the number
buttons to input the channel numbers (read note on the
right for details).
•
On the unit – press SKIP CH+/SKIP CH–.
Watching images from connected devices
Watching images from connected
devices
To select viewing a device connected to your unit (e.g.
satellite receiver, camcorder), press INPUT on either the unit
or remote control to show the action bar at the bottom of
the screen. Select the input source (DV, AV1, AV2 or Tuner)
by pressing
or
and then OK.
14
3:36 PM
Page 16
When using the number buttons to change channel:
1. Input firstly the channel number.
2. Press
.
3. Input the index number. Input "000" for analog (NTSC)
channels
4. Press OK to tune to the channel.
For example, to tune to channel 003-012, press "3",
"2" and OK.
If you only input the channel number and then press OK, the
unit will perform channel search for all the channels start
with the selected channel number (in the above example, all
channels start with 003-XXX). The first channel of the
selected channel number will be tuned to.
•
When viewing ATSC broadcasts, press INFO and
then
or
to select and display the information
on the current channel.
•
Press AGAIN/GO BACK to switch between the
current and the last tuned channels when watching
TV.
, "1",
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
