Canopy Assembly; Blade Assembly - Craftmade FRESCO FRS52-LED Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then tighten
both screws securely.
Slide canopy cover up to canopy, aligning rounded
part of slotted holes in canopy cover with screw
heads in bottom of canopy. Turn canopy cover to
the right (clockwise) until it stops.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.

8. Blade Assembly.

WARNING: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble
the blades. If screws are overtightened, blades
may crack and break.
Time Saver: Washers for blade screws can be
set on each blade screw prior to installing the
blades.
Locate 15 blade attachment screws/fiber
washers in hardware pack. Align holes in
blade with corresponding holes in blade
arm on topside of motor housing. Insert
3 blade attachment screws/fiber washers with
fingers first and then, starting with the screw
in the middle, tighten screws securely with a
Phillips screwdriver. Repeat procedure for the
remaining blades.
NOTE: Tighten blade attachment screws twice
a year.
antenna
canopy
screw
page 8
hanging bracket
screw
canopy cover
blade attachment
screws/fiber washers
blade
motor
housing