Status Indication - Bühler technologies BPM Guía Rápida

BPM

5.2.1 Status Indication

• Measurement
running
• Laser adjusts (flashing) at the start of each meas-
• Device paused II
5.2.2 Time
• Measurement running:
Specifies the elapsed or remaining time for the current
measurement depending on the operating mode. Spe-
cified in [minutes:seconds]
• Pause mode:
Indicates the time until the next measurement. Specified
in [minutes:seconds]
• When changing the pause time in pause mode and it is
less than the elapsed time, the display will read "- - : - -".
The information will display until the original time re-
maining has expired.
After that, a new pause time is active.
5.2.3 Displayed Standard
Information about the current standard displayed, ISO, SAE,
NAS or GOST. This is selected from the menu.
5.2.4 Ordinal Numbers
Display of the ordinal numbers for the last measurement. The
number of ordinal numbers can vary depending on the selec-
ted standard. Standards GOST and NAS only show one ordinal
number.
NOTICE! Ordinal numbers according to ISO 4406 between
1 and 6 are always displayed as ≤ 6. According to
ISO 4406, the ordinal number for the 21 µm measuring
channel is not analysed. The measured value, however, is
displayed as additional information and indicated as a re-
duced size.
5.3 Menu And Operation
The [ ] or [ ] key is used to navigate the menu and entries.
Press the select key [ ] to jump to the next level. To go back,
simultaneously press the [
To change values, press the [
place.
The number to change will be marked, then use the arrow
keys [ ] and [ ] to change. Press [
confirm and apply the changes.
Jumping to the higher level before the last confirmation, the
changes will be discarded.
16 Bühler Technologies GmbH
urement for approx. 2 to 3
seconds.
] and [ ] key.
] key to jump to the next
] after the last place to
BX150102 ◦ 03/2021