Zero Position; Work Position; Spit Position; Headrest - Olsen INFINITY Guía De Operación

5.9.1 - Zero Position

Press the Zero Position key to automatically adjust the seat to the lowest position and
backrest in the highest position simultaneously, to facilitate patient entry and exit.

5.9.2 - Work Position

To save a work position:
1º - Press the Zero Position key (section 5.8.1);
2º - Adjust the backrest to the desired position;
3º - Adjust the seat to the desired position;
4º - Press the Work Position key for 5 seconds. The equipment will emit 2 long beeps;
5º - Press command 1 (Seat Up) while the equipment beeps; The equipment will emit 2 short beeps to confirm
the procedure;
Note: the time to record the working position is only 2 seconds between steps 4 and 5, then when you hear the
first long beep (step 4), quickly press one of the available commands (1 to 3) to record the working position. If
none of the 3 commands is pressed in these 2 seconds, the equipment will emit 3 short beeps, canceling the
operation.
6º - Press the Zero Position key.
Repeat the previous steps by replacing the command 1 by the command 2 (Backrest Up) to record the
working position 2 or by the command 3 (Seat Down) to save the working position 3.
To perform a working position:
1º - Press the Work Position key; The equipment will emit a short beep;
2º - Press the command for the desired saved working position (1 to 3); The equipment beeps twice confirming
the operation.
The dental chair moves the backrest and seat simultaneously to the previously saved position and lights
the operating light at the last intensity used.
Note: after pressing the Work Position key, the time for position selection is 4 seconds. If no key is pressed within
this time, the equipment cancels the operation.

5.9.3 - Spit Position

To perform the spit position:
1º - Press the Work Position key (section 5.8.2);
2º - Press the command 4 (Backrest Down).
The equipment emits 2 beeps, turn Off the operating light, the backrest goes up and activates the water in
the bowl. After 8 seconds, the equipment returns to the position before the command.
Note: the spit position is pre-recorded at the factory and cannot be changed.

5.9.4 - Headrest

To adjust the headrest (2) position: press the button (1) to move the headrest
(2) to the desired position, then release the button.
To adjust the height of the headrest: move the bar (3) until you reach the
position. The headrest bar (3) allows adjustment with up to 10 cm from the
backrest.
Seat Up ( )
Backrest Up ( )
Seat Down ( )
Backrest Down ( )
13