Fanaway EVO1 LED Manual De Instrucciones página 5

Fanaway EVO1 LED Installation Instructions
To hang your fan where there is an existing fixture but no ceiling joist, you may need an installation hanger
bar (C) as shown in Fig.5. Make sure the hanger bar you purchase has been designed for use with ceiling
fans.
Remove the ball joint (4) from down rod (6) by loosening the set screw (3), insert the motor wires (1) and LED
1)
light cable (2) through the down rod (6).
Insert the down rod to the coupling (8), line up the coupling holes with the down rod holes and insert the bolt
2)
(9). Then insert the pin (10) to the end of the bolt.
Secure the down rod and coupling by tightening the two set screws (11) on the coupling.
3)
Feed the bolt and pin cover (7) and the canopy (5) through the down rod.
4)
Secure the ball joint back to the down rod. Fig. 6
5)
NOTE: When installing the fan with extension down rod, please use the LED light extension cable (19 -
Fig. 1).
5 | P a g e
Fig. 5
INSTALLING THE DOWN ROD
Fig. 6
L D - 0 0 0 3 - 1 5 / X X X / L E D / 0 1