Fanaway EVO1 LED Manual De Instrucciones página 9

Fanaway EVO1 LED Installation Instructions
INSTALLING THE REMOTE BATTERY
2 x AAA 1.5V (size) batteries are required to operate the remote control. Remove the battery cover from
the back of the remote and insert 2 x AAA batteries. Ensure the polarities are correct as shown in the
battery compartment. (Batteries included.)
OPERATING THE REMOTE:
Before you start using the remote, take the time to read through this section and
get familiar with the buttons and function of each button.
1. LED Indicator
The red LED indicator on the top of the transmitter will flash when the buttons are
active.
BUTTONS ON THE REMOTE
2. HI: Press this button to set the fan running at High speed.
3. MED: Press this button to set the fan running at Medium speed.
4. LOW: Press this button to set the fan running at Low speed.
5. OFF: Press this button to turn OFF the fan.
: Press this button to change the color temperature in the following order:
6.
3000K → 5000K → 4000K → 3000K
: Press this button to turn ON/OFF the light and press and hold the button to access the light dimming
7.
function.
The remote has memory function. If the fan or light is turned off by the isolating switch, it will memorise and recover
the last status when turned on next.
INSTALLING THE TRANSMITTER HOLDER
Install the holder to the wall with two screws provided, hang up the transmitter by the holder.
Fig. 15
9 | P a g e
Fig. 14
L D - 0 0 0 3 - 1 5 / X X X / L E D / 0 1