Important; Testing Your Fan - Craftmade South Beach SB52 Guia De Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

9. Light Kit Assembly (Optional). (cont).
Connect WHITE wire from light kit fitter to WHITE wire from
switch housing. Connect BLACK wire from light kit fitter to
BLUE (or BLACK) wire from switch housing. Be sure molex
connections snap together securely.
Align holes in switch housing cap with holes in switch housing.
[NOTE: Gap on edge of switch housing cap must align with
reverse switch in switch housing for proper fit.] Re-insert
screws that were previously removed. Securely tighten all 3
screws with a Phillips screwdriver.
Install 1 medium base 9-watt LED bulb (included).
IMPORTANT: When replacing bulb, please allow bulb and glass
shade to cool down before touching.
Locate slots on glass shade and align with dimples on light kit
fitter. Push up gently on glass shade and turn in a clockwise
direction until it no longer turns. Pull down gently on glass
shade to make certain that it is secure.

10. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with pull chain
on switch housing. Start at the OFF position (no blade
movement). First pull will set the fan to HI. Second pull
will set the fan to MEDIUM. Third pull will set the fan to
LOW. Fourth pull will again set the fan to the OFF
setting. Test light with pull chain on light kit fitter
(diagram 1). If fan and/or light does not function,
please refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air depending
on the season:
- DOWN position in summer (diagram 2)
- UP position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your comfort.
Important: Reverse switch must be set either
completely DOWN or completely UP for fan to function.
If the reverse switch is set in the middle position
(diagram 4), fan will not operate.
Attach pull chain extensions supplied or custom pull
chain extensions (sold separately) to the end of the
pull chains.
switch
housing
connections
light kit fitter
glass shade
reverse switch
pull chain
extension
diagram 1
diagram 2
page 8
molex
bulb
diagram 3
diagram 4
switch
housing
cap
dimple
slot
pull chain
extension

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido