Pahlen LED 350 50AP Manual De Uso página 13

Spotlight LED 350 50AP
Option 1
Colour Item no.
Cool white - 124840, 125840
Warm white - 124841, 125841
RGB - 124842, 125842
Option 2.
Colour Item no.
Cool white -
124840, 125840
Warm white -
124841, 125841
RGB - 124842, 125842
This is the way you install the cable to the LED module:
Connector installation
1
Connector installation
1
1. Loosen screws in socket (B) so that the hole for cable opens
3 leaving space enough for actions with cable guides.
3
4
page 6 of 20
3. Make sure the cable cover goes right under the socket.
page 6 of 20 If the cable is not dragged sufficiently far, there is a risk that the
silicone seal will not function properly. Water may then leak into
the lamp.
5
5. Cut or cut off the piece of the guide that sticks
through the socket
Max cable length / Cable cross section
1.5 mm
2
77 m
77 m
62 m
Max cable length / Cable cross section
Quantity
of lamps
2.5 mm
2
1 129 m
2 64 m
3 43 m
4 32 m
1 103 m
2 51 m
3 34 m
4 25 m
A
Connector installation
2
1
2
3
4
page 6 of 20
5
6
page 7 of 20
2.5 mm 4.0 mm
2 2
129 m 207 m
129 m 207 m
103 m 165 m
4.0 mm 6.0 mm
2 2
207 m 311 m
103 m 155 m
69 m 103 m
51 m 77 m
165 m 248 m
82 m 124 m
55 m 82 m
40 m 62 m
B C D
2
2. Pull seal (C) onto the cable (E)
Pull cable guide through the socket.
4
4. Tighten screws.
5
Make sure the screws are firmly seated.
6
6. Align the socket into the LED module (A).
Make sure the seal is properly sealed.
Tighten nut (D).
13
ENGLISH
Transformer power [VA]*
6.0 mm
2
311 m 16
311 m 16
248 m 12
Transformer power [VA]*
10.0 mm
2
519 m 16
259 m 32
173 m 48
129 m 64
414 m 12
207 m 24
138 m 36
103 m 48
E
A LED-module
B Connector/Socket
C Silicone packing
D Nut
E Cable
6
page 7 of 20
page 7 of 20