Before Use - Kenwood KDC-X895 Guia De Inicio Rapido

Before use

2 WARNING
To prevent injury or fire, take the
following precautions:
• Stop the car before operating the unit.
• To prevent a short circuit, never put or
leave any metallic objects (such as coins
or metal tools) inside the unit.
¤
CAUTION
• Adjust the volume so that you can hear
sounds outside the car. Driving with the
volume too high may cause an accident.
• Wipe off the dirt on the panel with a dry
silicon or soft cloth.
Failure to observe this precaution may
result in damage to the monitor or unit. "
Cleaning the connector
Wipe off dirt on the connector of the unit
and panel. Use a cotton swab or cloth.
Condensation
When the car is air-conditioned, moisture
may collect on the laser lens. This may cause
disc read errors. In this case, remove the disc
and wait for the moisture to evaporate.
Notes
• If you experience problems during
installation, consult your Kenwood dealer.
• When you purchase optional accessories,
check with your Kenwood dealer to make
sure that they work with your model and
in your area.
• Characters that conform to ISO 8859-1
can be displayed.
• The illustrations of the display and the
panel appearing in this manual are
examples used to explain more clearly
how the controls are used. Therefore,
what appears on the display in the
illustrations may differ from what appears
on the display on the actual equipment,
and some of the illustrations on the
display may be inapplicable.
About discs used with this unit
• This unit can only play the CDs with
.
• The following discs cannot be used:
- Discs that are not round
- Discs with coloring on the recording
surface or discs that are dirty
- Recordable/Rewritable disc that has
not been finalized (For the finalization
process, refer to your disc writing
software, and your disc recorder
instruction manual.)
- 8 cm (3 inch) disc (Attempt to
insert using an adapter can cause
malfunction.)
Handling discs
• Do not touch the recording surface of
the disc.
• Do not stick tape etc. on the disc, or use a
disc with tape stuck on it.
• Do not use any accessories for the disc.
• Do not use any solvents to clean discs.
Use a dry silicon or soft cloth.
• Clean from the center of the disc and
move outward.
• When removing discs from this unit, pull
them out horizontally.
• Remove the rims from the center hole
and disc edge before inserting a disc.
How to reset your unit
If the unit fails to operate properly, press
the Reset button. The unit returns to factory
settings when the Reset button is pressed.
Reset button
English | 3