Installation/Removal Of The Unit - Kenwood KDC-X895 Guia De Inicio Rapido

Installation/Removal of the unit

Non-Japanese cars
Bend the tabs of the mounting sleeve
with a screwdriver or similar utensil
and attach it in place.
⁄
• Make sure that the unit is installed
securely in place. If the unit is unstable, it
may malfunction (for example, the sound
may skip).
Japanese cars

Refer to the section <Removing the hard
rubber frame> and then remove the
hard rubber frame.

Align the holes in the unit (two locations
on each side) with the vehicle mounting
bracket and secure the unit with the
accessory screws.
T
N
3
8 mm
MAX.
ø5mm
Accessory3...for Nissan car
Accessory4...for Toyota car
14 | Quick Start Guide
N
T/N
T
T: Toyota cars
N: Nissan cars
4
8mm
MAX.
ø5mm
Removing the hard rubber frame

Engage the catch pins on the removal
tool and remove the two locks on the
upper level.
Lift up and pull the frame forward as
shown in the figure.
Removal tool (Accessory

When the upper level is removed,
remove the lower two locations.
⁄
• The frame can be removed from the
bottom side in the same manner.
Removing the unit

Refer to the section <Removing the hard
rubber frame> and then remove the
hard rubber frame.

Remove the faceplate.

Insert the two removal tools deeply into
the slots on each side, as shown.

Lower the removal tool toward the
bottom, and pull out the unit halfway
while pressing towards the inside.
¤
• Be careful to avoid injury from the catch
pins on the removal tool.

Pull the unit all the way out with your
hands, being careful not to drop it.
Catch
Lock
2
)
2
Accessory