Dos And Don'ts - Tommee Tippee PERFECT PREP day & night Manual Del Usario

FAQs
Where is the best place to keep my Perfect Prep?
The Perfect Prep should be kept in a cool, dry location,
avoiding direct sunlight and kept away from warm
appliances. This is recommended to avoid the tank
temperature getting too warm.
What does the hot shot do?
The hot shot helps to dissolve the formula powder quickly
and easily, it also kills bacteria which may be present in the
formula itself. The water dispensed in the hot shot is at a
temperature of over 70°C.
How often do I need to change the filter?
On average the filter should last around 3 months, however
this depends on the frequency of use and what size bottles
you are preparing.
Why do I have to use a Tommee Tippee filter?
Most standard water filters do not include an anti-bacterial
filtration membrane, so even if they fit in your machine, they
will NOT remove the same level of bacteria.
Why do I need to submerge the filter before
first use?
Submerging primes the filter before use, ensuring that any
air bubbles or loose particles within the filter are removed
prior to use.
How long can I leave unused water in the tank?
Water is a food stuff. We recommend using it within 1-2
days.

Dos and Don'ts

It is essential that good hygiene practices are observed in
the use and maintenance of your Perfect Prep machine.
Dos
✓ Ensure your hands and all surfaces that come in to
contact with the machine and its components (including
filter) are clean.
✓ Before first use clean the machine following the set up
steps on the screen.
✓ Keep the machine away from direct sunlight.
✓ Only use cold tap water during regular use.
✓ Keep the outside of the machine clean.
✓ Be careful when handling hot water.
✓ Always adjust the height of the bottle stand so the
bottle neck is close to the dispensing spout. This is to
maintain the temperature of the water and to avoid any
splashes.
✓ Keep well clear of the dispensing spout as the unit
produces steam and very hot water.
✓ For your child's safety always check the food
temperature before feeding.
DON'TS
Do not allow the water tank to be contaminated. The
✗
inside of the machine should be cleaned by following
the cleaning process in this leaflet.
Do not clean with solvents or harsh chemicals.
✗
The machine is intended for use in a kitchen. It is not
✗
suitable for use in a nursery.
Do not use hot water other than during cleaning cycles.
✗
If water in the tank is lower than 5°C or higher than
28°C, the machine will not operate. If this happens,
either change the water or allow the water to cool and
restart.
Do not pour boiling water over the water filter.
✗
When topping up the hopper, do not fill beyond the max
✗
icon.
Be careful not to spill any water on the outside of the
✗
machine.
Do not remove the back panel from the machine.
✗
INFORMATION ON THE
DISPOSAL FOR WASTE
ELECTRICAL & ELECTRONIC
EQUIPMENT (WEEE)
This symbol on the products and accompanying documents
means that used electrical and electronic products should
not be mixed with general household waste.
For proper disposal for treatment, recovery and recycling,
please take these products to designated collection points
where they will be accepted on a free of charge basis. In
some countries you may be able to return your products to
your local retailer upon the purchase of a new product.
Disposing of this product correctly will help you save
valuable resources and prevent any possible effects on
human health and the environment, which could otherwise
arise from inappropriate waste handling.
Please contact your local authority for further details of
your nearest collection point for WEEE. Penalties may
be applicable for the incorrect disposal of this product in
accordance with national legislation.
The product is fitted with a BS 1363 mains plug containing
a 5A fuse. If it ever becomes necessary to replace the fuse,
only use fuses that are marked BS 1362, and rated at 5A. In
the unlikely event that this plug is not suitable for the
sockets in your home, it should be removed and a suitable
plug fitted as follows: The wires of the mains lead are
coloured in accordance with the following code:
GREEN AND YELLOW – EARTH
BLUE – NEUTRAL
BROWN – LIVE
As these colours may not correspond with the coloured
markings sometimes used to identify the terminals in the
plug, connect as follows. The wire coloured GREEN AND
YELLOW must be connected to the terminal marked E or
by the earth symbol or coloured GREEN or GREEN AND
YELLOW. The wire coloured BLUE must be connected to
the terminal marked N or coloured BLACK. The wire
coloured BROWN must be connected to the terminal
marked L or coloured RED. If you are in any doubt about
how to wire a plug or replace a fuse safely, consult a
qualified electrician.
Don't forget to register your Perfect Prep machine.
For details of how to do this, go to
tommeetippee.co.uk/product-registration