Technical Data; Noise Information; Vibration Information - Ratio AR144-3NM Manual De Instrucciones

TECHNICAL DATA

Type AR144-3NM (CDH-designation of machinery, representative of rotary hammer)
Voltage
No load speed
Impact rate
Impact energy
Battery type
Charger time
Battery capacity
Battery pack quantity
Max. drilling capac-
ity
Machine weight (without battery)
Charger input
Rated power
Charger output

NOISE INFORMATION

A weighted sound pressure
A weighted sound power
K & K
PA WA
Wear ear protection.

VIBRATION INFORMATION

Vibration total values (triax vector sum) determined according to EN 60745:
Mode description
Hammer drilling into concrete
Drill only
WARNING: The vibration emission value during actual use of the power tool can differ from
the declared value depending on the ways in which the tool is used dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti vibration accessories are used.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand-arm vibration syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of exposure level in the actual conditions of use
should also take account of all parts of the operating cycle such as the times when the tool is
switched off and when it is running idle but not actually doing the job. This may significantly reduce the
exposure level over the total working period.
Helping to minimise your vibration exposure risk.
Steel
Wood
Masonry
Vibration emission value
a
h,HD
a
h
= 10.85 m/s
2
= 5.4 m/s
2
0-900 /min
0-4300 bpm
1.3 Ah Li-Ion
100-240 V ~ 50/60 Hz
17.5 V
L : 87 dB(A)
pA
L : 98 dB(A)
wA
Uncertainty K
K = 1.5 m/s²
K = 1.5 m/s²
14.4 V
1.1 J
Li-Ion
60 min
1
8 mm
16 mm
10 mm
1.38 kg
40 W
1500 mA
3.0 dB(A)
33