Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
The module may be used to operate the motors of
two rolling shutters or sunblinds.
Electrical specifications
• Bus powered: 4 CU (considering total use for two
(1)
rolling shutters)
• Bus terminal configurable by means of dip-switch:
(2)
TERM
• Relay outputs:
- 230 V~ / 4 A on inductive load
- Use of high inrush current (80 A)
• Five terminals for two pairs of buttons for local
operation of the two motors (up, down), useful for
operating the rolling shutters or sunblinds in the
(3)
immediate proximity
.
(1) In detail: CU = 0.5 + 1.75 x N, where N is the number of rolling
shutters used (N=1 or 2).
(2) IMPORTANT: The "ON" position of the dip-switch is opposite to
the "ON" position on 1071/43.
(3) Max distance: 70 m.
DS1071-020A
Logical features
• Configurable with IPerSet software, via USB (see
1071/56)
• 254 possible logical addresses
• Three times for each rolling shutter: opening/
closing time, winding time, packing time
• Operation of each rolling shutter for max. 25
events (sensors or buttons)
• For each curtain or rolling shutter:
- Nine standard Actions: up, down, up always,
down always for controlling sets of rolling
shutters and possibility of adding delays for
offsetting drives and eliminating consumption
peaks, up/down allowing to use only one
control button, go to position etc.
- Three additional modes, each with nine
standard actions. Eleven Actions for selecting
the operating mode. The operating mode can
be programmed according to context (e.g.
weekdays/weekends).
- 15 cut-out Actions (neutral, open upon
activation, close upon action).
- 10 Actions, including 'override down' and
'override up'.
- Five block Actions, in case of emergency.
- Two pairs of timed actions for opening in the
7
Publicidad
