Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
LW18REV0509:Air Sanitizer Manual 3L ver 2
DIRECTIONS FOR USE
AC POWER CORD OPERATION
1. Set up for UV-C Sanitizer Wand: Insert power cord connector
into the handle of the UV-C Sanitizer Wand. (Fig. 1) Plug AC
cord into electrical outlet.
2. To Turn On: Simply press and hold the switch for 3 seconds.
LED screen will display "00" and beep to indicate the
activation. (Fig. 2) Press the switch again to select the
operating mode. UV-C Sanitizer Wand will not light up until
the operating mode is selected. If no operating mode is
selected within one minute, unit will automatically turn off.
3. To Turn Off: No matter which operating mode is in use,
press and hold the switch for 3 seconds, and the unit
will turn off. (Fig. 3)
BATTERY OPERATION
1. Use a Phillips screwdriver to open the battery cover. Insert
4 AA Alkaline batteries and close the cover. (Fig. 4)
2. To Turn On: Simply press and hold the switch for 3 seconds.
LED screen will display "00" and beep to indicate that the
UV-C Sanitizer Wand is on. (Fig. 2) Press the switch again to
select the operating mode. UV-C Sanitizer Wand will not light
up until the operating mode is selected. If no operating mode
is selected within one minute, unit will automatically turn off.
3. To Turn Off: No matter which operating mode is in use, press
and hold the switch for 3 seconds, and the unit will turn off.
(Fig. 3)
4. Power Shortage: LED light will start to flash and start
beeping when the batteries are running low on power.
(Fig. 5)
E-6
5/15/09
11:47 AM
Page 4
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
OPERATING MODES
UV-C Sanitizer Wand has three different operating modes:
5 Minute Operating Mode, 60 Minute Operating Mode, (This is the recommended mode
of operation) Continuous Operating Mode.
05
1. 5 Minute Operating Mode (
) (Fig. 6):
A. Note that when the unit is on or in Continuous Operating
Mode, push once to enter 5 Minute Operating Mode. UV-C
bulb will light up, LED screen will display 5 minutes. It will
start counting down in 3 seconds.
B. When selecting 5 Minute Operating Mode, all product
systems will automatically shut off after 5 minutes.
C. To turn off the UV-C bulb before 5 minutes, simply press
and hold the switch for 3 seconds.
60
2. 60 Minute Operating Mode (
) (Fig. 7):
A. When LED screen display is in 5 Minute Operating Mode,
press the switch one time to enter to Basic Mode
(60 minutes). LED screen will display 60 minutes. It will
start counting down in 3 seconds.
B. When operating 60 Minute Operating Mode, all product
systems will automatically shut off after 60 minutes.
C. To turn off the UV-C bulb before 60 minutes, simply press
and hold the switch for 3 seconds.
CC
3. Continuous Operating Mode (
) (Fig. 8):
A. When LED screen display is in 60 Minute Operating Mode,
press the switch one time to enter Continuous Operating
Mode. LED screen will display CC and remain still.
CC
B. In Continuous Operating Mode (
) the UV-C bulb will
remain lit. All product systems will not shut off until the
power is turned off or running out of battery power.
C. To turn off the unit, simply press and hold the switch
for 3 seconds.
Fig. 6
Fig. 7
Fig. 8
E-7
Publicidad
Tabla de contenido
