Removing The Header Assy - NAMCO MARIO KART Manual Del Operador

5-1

Removing the Header Assy

The fitting position of the Header Assembly is high, and it is important that
a means of reaching the height safely, without stretching, is available. (e.g.
Steps, Step Stool etc.)
1. Remove 6off pozi head screws (3 each side).
2. Lift the header assembly sufficient to reach the connector.
3. Disconnect the connector and remove the Header assembly.
Pozi head screw
(M5x12)
4. Reassemble in reverse order.
Connector
Page 37
Pozi head screw
(M5x12)