Tabla de contenido
Publicidad
BUILDING BASICS
Getting Started:
To begin your model, find step number
follow the numbers. Each piece has its own shape
and color. Look at the pictures, find the pieces that
match what you see, and connect them together.
It helps to face your model in the same direction
as the instructions while you build. The arrows
show you where the parts connect, but not all
connection points have arrows. The faded color
parts are the ones you have already put together.
3
1
2
4
-
1
3
Spacers:
There are places in your model where you need to
add blue and silver spacers. Be sure to use the
right color and count them carefully.
Light-Up Rods:
Be sure to use the correct ends of the light-up rods
when building. There are two different ends on the
light-up rods. The end with the metal tip (contacts),
must fit tightly into the light-up module. Push the
metal ends of the light-up rods firmly into the
light-up module to make contact. The other end
can fit into a connector.
1
and
Parts Count:
Before you start building, be sure to compare the parts
in your set with the parts listed here. If anything is
missing, call or write to us using the information on
the back cover. We're here to help!
FCC Statements:
!
W RNING: Changes or modifications to this unit not
expressly approved by the party responsible for the compliance
could void the users right to operate the equipment. This device
(Light-up module) complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference received, including
interference that may cause undesired operation. This model is
Connectors:
You can slide these special connectors together.
Push tightly until you hear a "click". Pay close
attention to the instructions and position them
horizontally or vertically exactly as they are shown.
tested to comply with FCC standards - FOR HOME OR OFFICE USE.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protec-
tion against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy, and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communi-
cations. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures: (1) Reorient or relocate the receiving
antenna. (2) Increase the separation between the equipment
and receiver. (3) Consult the dealer or an experienced radio/TV
technician. This Class B digital apparatus complies with
Canadian ICES-003.
Publicidad
Tabla de contenido
