Establishing Operational Readiness - Oase ProMax Garden Automatic 3500 Instrucciones De Uso

5. Remove the connected hoses on the
pressure and suction side.
6. Undo the water drain screw and tip the
pump to allow the residual water to drain
out.
7. Screw in the water drain screw again.
16
OPERATION
1
2
3
4
• Cycle: Sensors monitor the water flow
and the water pressure, and switch the
pump on, off or into standby after a cer-
tain time when the pump cannot extract
any more water or the pressure line is
closed.
• The lit or flashing LEDs in the ON/OFF
button indicate the respective operating
status. (→ Operating status and atten-
dant LED displays)

Establishing operational readiness:

Connect the pump to the power supply.
• The pump is ready for operation.
• All LEDs are lit.
For switching the pump on and off:
Press the ON/OFF button for less than 3 s.
• Once it is switched on, the automatic
mode takes control of the pump: Sen-
sors repeatedly monitor whether the
water flow is below the minimum flow
rate or the water pressure below 1.5 bar.
Depending on the result, the pump is ei-
ther operated with dry-run protection or
is switched back into standby by auto-
matic mode.
Resetting automatic mode: Press the
ON/OFF button for at least 3 s.
ProMax Garden Automatic 3500/4000/5000/6000
Blue LED
Yellow LED
Red LED
ON/OFF button
POX0041