Lenco ODR-150 Manual Del Usuario página 8

Initial use
Before operation, please make sure that the VOLTAGE mentioned on the power supply is same as
the voltage of your local area.
Use the supplied mains adaptor to connect the device to a household mains socket.
Long press the "Power" button to switch the device.
Basic operation-getting started
Basic operation-getting started
1. Plug in the power adaptor, fully extend the antenna, long press the "Power" button.
2. The display backlight will Light up andthe clock(00:00)(Time is not set) will flash
3. On the very first use the DAB mode will automatically be selected and the radio will perform
a full scan. The display will show 'Scanning'with a bar indicator showing the scan progress and
the total number of stations found.
4. When the scan is finished the radio will play the first alphanumerically found station. If the
radio does not find any stations, 'No DAB Station' will be displayed.
5. Adjust the volume to the desired level using the "VOL(+/-)" knob.
6. Press the stations button and use knob to scroll through the stations list. Press the "Enter" knob
on your favorite station.
7. Press the "Mode" button to switch between DAB, FM, Bluetooth and Aux input mode,
8. Long press the"Power" button to switch between standbyand working mode.
9. Press "EQ" button to select the EQ from Normal, Classic, Jazz, Pop, Rock, Speech, My EQ.....
Using the radio- DAB mode
DAB Mode- Full scan
This function will scan for all available DAB stations, Band III channels.
In DAB mode, press "Menu" button and rotate the "Enter" knob to select 'Full Scan', then short
press the "Enter" knob to start the DAB full scan. When the scan is finished, the radio will return to
the last played DAB radio station. All stations found will be listed in the station list, which is show
when pressing the 'stations' button.
8