Aroma Function; Programming Your Coffee Maker - Krups KM720 Manual Del Usario

English
8- With the top lid firmly closed and the carafe securely in place, press the On button.The red On LED
will light up to indicate the brew cycle has started.
Note: When the brewing process ends and the water level indicator is empty, there will still be hot liquid
in the filter basket.Wait a few minutes for the rest of the liquid to drip through into the carafe.
9- After coffee grounds have cooled, open the top lid and carefully remove the filter basket by grasping
the tabs on each side of the filter basket , and lifting straight up from the filter basket holder. Discard
the used coffee filter and grounds Fig. 8 and 9.
CAUTION: The coffee maker becomes very hot during the brew cycle. Please handle
with extreme care.
Notes:
- The keep warm plate will operate, up to two hours, as long as the on/off button is on (red LED is lit).
- Always switch the coffeemaker to Off when the carafe is empty or you no longer want to keep coffee hot.
- If two or more pots of coffee are to be made it is recommended that the coffeemaker be allowed to cool
for 10 minutes between each brewed pot. The filter basket should also be rinsed out after each brew
cycle.
Auto Shut-Off
As a convenience, your coffee maker has been designed with an Auto Shut-Off feature. When the brewing
cycle is completed, the coffee maker will shut off automatically after 2 hours.

4. AROMA FUNCTION

To ensure optimum flavor, the AROMA button allows you to adjust the intensity of the coffee prepared:
Follow the directions for MAKING COFFEE until step 7.
Press AROMA button to select a stronger strength of brew.
Press the On button.The red On LED will light up to indicate the brew cycle has started.
Note: This function will slow down the flow of water into the filter basket. It will provide a rich coffee flavor.
- When the brewing process ends and the water level indicator is empty, there will still be hot liquid in the
filter basket. Wait a few minutes for the rest of the liquid to drip through into the carafe.
Note: To desactivate the AROMA function, press the AROMA button again.

5. PROGRAMMING YOUR COFFEE MAKER

Setting the clock
You may set the clock any time before or after brewing.
Press the HOUR button and then the MIN button to set the current time. Press and hold the buttons
to scroll through numbers quickly.When the number displayed approaches the desired setting, press
and release the button to advance one digit at a time.
Note: AM is indicated in the upper left hand corner of the display and PM in the lower left hand cover.
Setting the auto brew start time
1- To set the desired auto brew start time press the PROGRAM button. The word PROGRAM will begin
flashing on the display to indicate an auto brew start time is being set.
8