Aroma Function; Water Filtration - Krups KT4065 Manual De Instrucciones

cafetie?re dahlstrom EU11.qxd:KM 8005 anglais.qxd
time the PROG is pressed. The blinking display and the
mode. After pressing the PROG button the screen should default back to the stand-by mode after 5 seconds
of inactivity, accepting the last programmed settings for auto-on and auto-off.
1- Auto-On setting #1: fig. 14 & 15
Press PROG (r) once, the AUTO program #1 is indicated with a red light (o).
Press the H and Min buttons (p) to set a time for the machine to brew automatically. You can press and hold
the buttons to move quickly through the hours or minutes.
The display will show digits with the current time.
Regular
Strong
2- Auto-On setting #2:
Press PROG (r) when done.
Press PROG (r) twice, the AUTO program #2 is indicated with a red light (o).
This second preset start time can be used for days with later start times, ie weekends.
After programming the automatic start time as described above, be sure to prepare the machine for a brew
cycle with water in the tank, coffee in the brew filter holder, lid closed and jug securely in place.
Press the Auto-On button (n) to choose preset number 1 or number 2. You can check the preset times by
pressing PROG (r).
The machine will brew automatically at the designated time. The program will need to be activated when
needed again.
3- Auto-Off setting (only for model
with glass jug):
Press PROG (r) 3 times, the number of hours will blink and the 2 red lights (o) on the control panel will blink.
Use the H button (p) to change between 1, 2 or 3 hours.
Press PROG when done.
This function controls how long the heating plate will continue before automatically turning off. For best
results we recommend brewing only as much coffee as you will consume in 30-60 minutes. Taste is affected

AROMA FUNCTION

the longer the coffee is allowed to sit on the heating plate.
This function is designed specifically for small batches, normally less than 6 cups, where brew cycles beco-
me too short to properly extract the coffee taste from the coffee ground.
Note : this function cannot be changed once the brew cycle has started.
To activate press the Aroma button (q), then press On.
The function can also be used for full pots but will cause more of the bitter flavours to be extracted in that
case. Krups recommends only using Aroma Control for small batches less than 6 cups.

WATER FILTRATION

18
5/03/09 10:35
icon alerts you that the unit is in a programming
Page 18
English