Care & Cleaning - Glacier bay 2258NNHD Guía De Uso Y Cuidado

[Heading goes here]
Installation (continued)
5
Mounting the unit to the wall
NOTE: For safety reasons, it is imperative that this unit
be mounted to the wall.
NOTE: Before cutting, drilling or hammering into any
wallsurface, verify the location of electrical, plumbing and
gas lines. Cutting any of these may cause serious injury.
□ Mark mounting points on the wall through the holes in the
top tubes (A).
□ Hammer wall anchors (DD) into the wall, unless the
mounting screws (CC) will go directly into a stud.
□ Place the unit against the wall, lining up the wall anchors (DD)
and holes in the top tubes (A).
□ Tighten the mounting screws (CC) into studs or wall anchors (DD).
Care and Cleaning
□ Cleaning with a dry cloth may be sufficient.
□ For other stains or marks, wipe gently with a damp cloth.
□ Do not use strong detergents or abrasive cleaners; they may damage the surface of this product.
8
DD
CC
A
mounting hole