Range Extender Spares - Orbea GAIN HYDRO Manual Tecnico

58 | OR B EA
INSTALLING THE RANGE EXTENDER ON GAIN
The Range Extender must be installed on the frame using the
Ebikemotion Range Extender cage included with the unit.
The installation of the Range Extender on Gain must al-
ways be done on the seat tube, using the threaded inserts
on the frame.
For its installation, detach the Range Extender from the
holder cage, then install the holder onto the seat tube.
4
5 N.m

RANGE EXTENDER SPARES

41 RANG E EXTE N D E R CAGE
ART Nº: X1250000
41.1 RANGE EXTENDER CAGE
41.2 RANGE EXTENDER SILICON BAND
41.3 BOLT M5x16
41.4 WASHER M5
TECHN ICA L MAN UAL
Always use the M5x16 bolts and washers in-
cluded with the Range Extender to install it
on Gain. The bolts for standard bottle cages
included with the frame if your bicycle did not
include a Range Extender originally are too
short for the weight of the Range Extender.
It is recommended to check the recommended settings
regularly to avoid damage to the frame or fixing hardware.
* It is not possible to install and/or connect two Range
Extender units on the same system/bicycle.
4 2 R A NG E EXT E N D ER S IL I C O N BAN D
QTY. ART Nº: X1260000
1 RANGE EXTENDER SILICON BAND
1
2
2
B LUE PAPER GAIN · HYDRO 2021
X 35 SYST E M CA BL E R OUT I NG
O N GAI N HYD R O
Iwoc One
QTY.
1
Read the Lights section of this manual to know
about the lights cable routing on Gain Hydro.
Charging point
PASS sensor
O RB EA | 59
EN
Motor cable