Stage 2 Tray Assembly - Evenflo exer saucer BABY ACTIVE Triple Fun Instrucciones

Stage 2 Base Assembly
H
F
5. Insert lower leg at an angle (as shown) onto top of lower leg pedestal
H
gently while applying a steady downward pressure until it clicks into place.
Swing lower leg up until it locks in the upright position. Repeat for all four lower
H
legs.
You are now finished assembling the two tube-base assemblies. Set them aside so
you can assemble the tray.

Stage 2 Tray Assembly

I J
M
E
L
K
H
H
, then rock
F
1. Locate two tray halves I . Insert locking clasp
underside of one tray half, as shown. It will be held in place
after completing the following step.
Repeat for other locking clasp on the other tray half.
2. Install spring , upper leg crown
K L
onto one of the tray halves. Secure with four screws
Note: Hold the upper leg crown and pylon ring
L
securely while installing screws. Tension from the spring will
try to push the upper leg crown and pylon ring upward.
Repeat for other upper leg crown on this tray half and for
both upper leg crowns on the other tray half.
1
4
M
I
Install and tighten screws on the
pylon ring M
sequence.
3
2
4
H
CLICK!
H
I
J on
, and pylon ring
M
E .
M
O
P
TIP
in the following
3. Insert upper leg
N N
clicks into place. Pull up on upper leg
securely installed in upper leg crown
Repeat until all four upper leg assemblies are
complete.
CLICK!
Note: Make sure the adjustment buttons on the front of
N
all four upper legs
L
tray
I
I
CLICK!
O
I1
P
I1
5
Stage 2 Tray Assembly
N into the upper leg crown L until it
N to ensure it is
L .
N are facing the outer edge of the
I , as shown.
4. Assemble the tray by snapping both tray
halves I together, as shown.
Note: Make sure the tray halves lock
securely.
5. Locate the large end cap and press it onto
O
mounting posts I > ! for storage, as shown.
Locate the small end cap and press it onto
P
mounting posts I > ! for storage, as shown.