Toy Assembly - Evenflo exer saucer BABY ACTIVE Triple Fun Instrucciones

Stage 2 Seat Assembly
N1
WARNING
Allow only the baby's toes to touch the floor. DO NOT
allow the baby to stand flat-footed on the floor. As baby
grows and becomes more active, raise the tray to the
next level so that baby enjoys the most comfortable fit
and maximum use of the spin and bounce features.
To adjust height:
ALWAYS remove baby from ExerSaucer ® before adjusting.
Push the button until the desired position is obtained.
N > !
Make sure that all four legs are adjusted to the same position.
8
Attach toys by routing Velcro® straps V through slots in tray
and fastening underneath. Pull up on the installed toys to
make sure they are secure.
To remove toys, unfasten Velcro® straps from underneath tray
and remove toy.
V
ON/OFF
Batteries

Toy Assembly

Batteries
ON/OFF
To install stalk toys, press firmly into tray as shown.
Pull up on stalk toys to make sure they are locked
in place.
To remove stalk toys, squeeze tabs W
toys from tray.
W
Remove
ON/OFF
Batteries
9
and lift stalk