Folding/Unfolding Stage 2; Important - Evenflo exer saucer BABY ACTIVE Triple Fun Instrucciones

Folding/Unfolding Stage 2

C
H
H
F2
I
G
1. To fold ExerSaucer®, ALWAYS remove baby and toy
bar(s) C from ExerSaucer® before folding.
With ExerSaucer® flat on the floor, twist each leg
assembly fully clockwise (the direction of the arrow)
H
until it stops in the position shown.
Note: Make sure the legs are at the same height
H
adjustment or the ExerSaucer® will bind and not fold
properly (refer to page 8).
Fully depress one of the pedestal locking tabs
push on the leg assembly H ; leg will partially fold. Repeat
this procedure for all four legs.
After pressing the fourth pedestal locking tab
ExerSaucer® will fold with the tray rotating toward the
I
base G .
2. Rotate locking clasp
J from underside of tray. Hook end of
locking clasp onto base tube , as shown.
G
Repeat for other locking clasp.
J
G
10
J
, then
F > @
F
Stage 3 is used for children who can walk unassisted up to approximately 24 months.
Stage 3
IMPORTANT: Child should not use the activity table if they can not walk by themselves.
F > @ , the
O
P
3. To unfold the ExerSaucer®, release the two locking clasps
and rotate them into their storage position under the
J
tray.
Hold the base down with your foot, and pull the tray
upward. The tray will rotate as you pull and the legs will
lock in the upright position. The leg assemblies
lock onto the lower leg pedestals
H
Twist the tray to make sure all legs are locked properly.
IMPORTANT: Make sure all four leg assemblies
F
firmly locked onto the lower leg pedestals
1. Turn ExerSaucer® upside down and remove two tubes
from base.
Note: Slide tab
G > # and push down button
of tube from opening in base foot, as shown. Store tubes for
Q
future use.
Q1
G3
2. Remove the large end cap
from beneath the tray I .
I
11
Folding/Unfolding Stage 2
H will
.
F
are
H
F before use.
Stage 3
Q
Q > ! ,then pull end
O and the small end cap P