Stage 3 Assembly - Evenflo exer saucer BABY ACTIVE Triple Fun Instrucciones

Stage 3 Assembly

I
I
I
I
3. Squeeze both locking tabs
each side of the tray to disconnect
and separate the tray halves
Re-position them as shown.
I2
4. Connect tray halves to form activity table.
I
CLICK! Note: Make sure the tray halves lock securely.
12
I > @ on
I .
O
5. Install the small end cap
locking tabs
opening, as shown.
P
I2
P
6. Turn table over and install the large end cap
shown. Make sure both end caps
into place.
7. Install toys on activity table. If desired, adjust table to
different height (page 8) for your child.
Note: Always make sure that all four legs are
adjusted to the same height.
IMPORTANT: NEVER use Stage 3 without end caps.
P
13
Stage 3 Assembly
P , as shown. Make sure the
have locked over the edge of the
I > @
O , as
and are locked
O P