brennenstuhl PIR 240 Instrucciones De Empleo página 9

PIR 240
INSTALLATION (see also Fig. 2)
Important:
1. The motion detector must be installed by a qualified electrician
in compliance with the I.E.C.'s regulations for wiring.
2. Before working on electrical appliances, make sure that the
power is turned off (breaker/ main switch).
3. Loosen the screw on the underside of the housing, remove the
mounting plate and take the terminal strip out of the bracket. If you
want to mount the motion detector on a 90°-corner of a structure,
use the enclosed corner bracket instead of the mounting plate.
4. Feed the power cord and the light cord through the rubber gasket
on the mounting plate/corner bracket.
5. Mount the mounting plate/corner bracket at the mounting location.
6. Connect the power cable and the light cable to the terminal clip
(see Fig. 2).
7. Put the terminal clip back in place.
8. Attach the housing on the mounting plate/corner bracket and
tighten the screw.
9. Turn the power on. Now you can adjust the motion detector to the
desired settings.
Control elements
Terminal strip
Mounting screws
Light
Power supply
Fig. 2
Power cord
Blue
Brown
Black
Earth
Light cord
Mounting plate
}
PIR
9