Clean Contact Connection; Default Setting; Operating Logic; Additional Setting - Gewiss JOINON WALLBOX I-CON DLM Manual De Uso E Instalación

Electric vehicle charging unit JOINON WALLBOX I-CON DLM
12.
62

CLEAN CONTACT CONNECTION

The charging station has a clean contact that can be used by external devices to check the charging station,
intervening in the current charging process.
The operating logic is combined with the position of selector number 4 of the DIPSWITCH on the electronic board.

12.1 DEFAULT SETTING

The default setting for selector n. 4 of the DIPSWITCH is OFF

12.1.1 OPERATING LOGIC

With the selector in this position, the operating logic is
ENABLING CONTACT
Open
Closed

12.2 ADDITIONAL SETTING

It is possible to change the position. The default setting for selector n. 4 of the DIPSWITCH is OFF
12.2.1 OPERATING LOGIC
With the selector in this position, the operating logic is
ENABLING CONTACT
Open
Closed
COLLEGAMENTO
USER CONNECTION
UTENTE
VEHICLE CHARGING MANAGEMENT
Charging enabled without external limitations.
The logics of the ECO or DLM mode are actuated
depending on how the charging station is set
Charging blocked or suspended
Charging is blocked if the signal arrives when the
station is in standby
Charging is suspended if the signal arrives when
the station is charging
VEHICLE CHARGING MANAGEMENT
Charging blocked or suspended
Charging is blocked if the signal arrives when the
station is in standby
Charging is suspended if the signal arrives when
the station is charging
Charging enabled without external limitations.
The logics of the ECO or DLM mode are actuated
depending on how the charging station is set