Safety Guidelines; Applications Recommended By Resideo; Technical Data; Assembly - resideo Braukmann KS10S Instrucciones De Instalación

1

Safety Guidelines

1. Follow the installation instructions.
2. Use the appliance
• according to its intended use
• in good condition
• with due regard to safety and risk of danger.
3. Note that the appliance is exclusively for use in the
applications detailed in these installation instructions
(see 3 Technical Data). Any other use will not be
considered to comply with requirements and would
invalidate the warranty.
4. Please take note that any assembly, commissioning,
servicing and adjustment work may only be carried
out by authorized persons.
5. Immediately rectify any malfunctions which may
influence safety.
2 Applications recommended by
Resideo
Type Resideo recommendations
KS10S-30
KS10S-60
KS10S-30 is certified by DVGW (Registration No. NW9151-
CO0166) for use in houses for 6-8 families or up to 20
persons.
3

Technical Data

Media
Medium:
Max. flow rate:
Connections/Sizes
Connection sizes:
Connection water output:
Pressure values
Operating pressure:
Nominal pressure:
Pressure loss during max.
flow rate:
Operating temperatures
Water temperature:
Ambient temperature:
Specifications
Mains voltage (ext.
transformer):
Micro fuse:
Power consumption:
Protective class:
MU1H-1417GE23 R0420
1-3 family dwelling
3-8 family dwelling
Drinking water
3
3.2 m /h
1" internal thread
1
/ " hose nozzle
2
1.3 - 8.5 bar
PN 10
2.0 bar
1 - 40 °C
2 - 40 °C
230 V / 50 Hz
24 V /50 Hz
2 W
IP 22
GB
The plant is designed for operation with salt tablets (acc. EN 973 Typ
A).
4

Assembly

4.1 Installation Guidelines
• All works should only be carried out by a qualified
installer
• Ensure that installation is not subject to freezing or
extreme heat
– Avoid direct exposure to sunlight
• The softening device should rest on an even surface
• If the input pressure is more than 5 bar, then a
pressure reducer needs to be installed ahead of the
softening device according to DIN 1988
• It should be checked whether a dosing device to
prevent corrosion should be added to the plant
• A filter (e.g. F76S) should be installed no more than 1
meter ahead in flow direction of the softening device
to protect the plant
• The following is needed for operation in the close
vicinity of the device:
– a channel interface (at least DN50)
– separate mains connection (230 V/50 Hz)
– floor drain
4.2 Assembly instructions
CAUTION!
To avoid irreplaceable damage to the softening
device, all welding and soldering work in the near
vicinity should be completed before the mounting.
1. Thoroughly flush pipework
2. Install softening device
• Note flow direction (indicated by arrow)
3. Install without tension or bending stresses
4. Establish the connections to the softening device
5. Connect the sewerage tube to the discharge
connection (inner tube ø min. 13 mm, 1/2")
CAUTION!
Make sure the seal is fitted properly!
3