To Reduce The Risk Associated With Ingestion Of Contaminants - GE PNM22LEK Instructivo Y Advertencias

Performance Data Sheet
Model: GE Appliances XWF - XWFE
System certified by IAPMO R&T against NSF/ANSI Standards 42, 53, 401 for the reduction of claims specified on the performance data sheet
and at iapmort.org.
Actual performance may vary with local water conditions.
Substance Tested for Reduction
Chlorine Taste and Odor
Chloramine Taste and Odor
Particulate, Class I
Cysts
Lead
Mercury
Asbestos
Toxaphene
VOC (Chloroform surrogate chemical)
Alachlor
Atrazine
Benzene
Carbofuran
carbon tetrachloride
chlorobenzene
chloropicrin
2,4-D
dibromochloropropane (DBCP)
o-Dichlorobenzene
p-Dichlorobenzene
1,2-dichloroethane
1,1-dichloroethylene
cis-1,2-dichloroethylene
trans-1,2-dichloroethylene
1,2-dichloropropane
cis-1,3-dichloropropylene
dinoseb
Endrin
Ethylbenzene
ethylene dibromide (EDB)
bromochloroacetonitrile
dibromoacetonitrile
dichloroacetonitrile
trichloroacetonitrile
1,1-dichloro-2-propanone
1,1,1-trichloro-2-propanone
heptachlor (H-34, Heptox)
heptachlor epoxide
hexachlorobutadiene
hexachlorocyclopentadiene
Lindane
methoxychlor
pentachlorophenol
simazine
Styrene
1,1,2,2-tetrachloroethane
Tetrachloroethylene
Toluene
2,4,5-TP (silvex)
tribromoacetic acid
1,2,4-Trichlorobenzene
1,1,1-trichloroethane
1,1,2-trichloroethane
trichloroethylene
bromoform
bromodichloromethane
chlorodibromomethane
xylenes
Meprobamate
Atenolol
Carbamazepine
DEET
Metolachlor
Trimethoprim
Linuron
TCEP
TCPP
Phenytoin
Ibuprofen
Naproxen
Estrone
Bisphenol A
Nonyl phenol
Maximum permissible
concentration product water
(mg/L) concentration (mg/L)
2.0 mg/L +/- 10% N/A
3.0 mg/L +/- 10% 0.5
At least 10,000/mL N/A
50,000/L N/A
0.15 0.01
0.006 0.002
N/A
0.015 +/- 10% 0.003
0.300 0.015
0.050 0.001
0.100 0.003
0.081 0.001
0.190 0.001
0.078 0.0018
0.077 0.001
0.015 0.0002
0.110 0.0017
0.052 0.00002
0.08 0.001
0.040 0.001
0.088 0.0048
0.083 0.001
0.170 0.0005
0.086 0.001
0.080 0.001
0.079 0.001
0.170 0.0002
0.053 0.00059
0.088 0.001
0.044 0.00002
0.022 0.0005
0.024 0.0006
0.0096 0.0002
0.015 0.0003
0.0072 0.0001
0.0082 0.0003
0.025 0.00001
0.0107 0.0002
0.044 0.001
0.060 0.000002
0.055 0.00001
0.050 0.0001
0.096 0.001
0.120 0.004
0.150 0.0005
0.081 0.001
0.081 0.001
0.078 0.001
0.270 0.0016
0.042 0.001
0.160 0.0005
0.084 0.0046
0.150 0.0005
0.180 0.0010
0.300 0.015
0.300 0.015
0.300 0.015
0.070 0.001
400 +/- 20% 60
200 +/- 20% 30
1400 +/- 20% 200
1400 +/- 20% 200
1400 +/- 20% 200
140 +/- 20% 20
140 +/- 20% 20
5000 +/- 20% 700
5000 +/- 20% 700
200 +/- 20% 30
400 +/- 20% 60
140 +/- 20% 20
140 +/- 20% 20
2000 +/- 20% 300
1400 +/- 20% 200
Avg %
Application Guidelines/Water Supply Parameters
Reduction
Service Flow
96.9
Water Supply
96.9
Water Pressure
91.4
Water Temperature
>99.99
Capacity
98.85
96.3 It is essential that the manufacturer's recommended installation,
>99
product to perform as advertised. See Installation Manual for Warranty
86.95
information.
99.7
> 98
Note: While the testing was performed under standard laboratory
> 97
conditions, actual performance may vary.
> 99
> 99
Replacement Cartridge:
98
of replacement elements please visit our website at
> 99
www.gewaterfilters.com
99
98
WARNING
> 99
> 99
• Do not use with water that is microbiologically unsafe or of
> 98
95
unknown quality without adequate disinfection before and
> 99
after the system. Systems certified for cyst reduction may be
> 99
used on disinfected water that may contain filterable cysts.
> 99
> 99
> 99 NOTICE
99
To reduce the risk of water leakage or flooding, and to
99
ensure optimal filter performance:
> 99
• Read and follow use instructions before installation and use of
> 99
this system.
98
• Installation and use MUST comply with all state and local
98
plumbing codes.
98
98
• Do not install if water pressure exceeds 120 psi (827 kPa). If
99
your water pressure exceeds 80 psi (552 kPa), you must install
96
a pressure-limiting valve. Contact a plumbing professional if you
>99
are uncertain how to check your water pressure.
98
• Do not install where water hammer conditions may occur. If
> 98
water hammer conditions exist you must install a water hammer
> 99
arrester. Contact a plumbing professional if you are uncertain
> 99
> 99
how to check for this condition.
> 99
• Do not install on hot water supply lines. The maximum
> 97
operating water temperature of this filter system is 100º F (38º
> 99
C).
> 99
• Protect filter from freezing. Drain filter when temperatures
> 99
drop below 33ºF (0.6ºC).
> 99
99
• Change the disposable filter cartridge every six months or
> 98
sooner if you observe a noticeable reduction in water flow rate.
> 99
• Failure to replace the disposable filter cartridge at
95
recommended intervals may lead to reduced filter performance
> 99
and cracks in the filter housing, causing water leakage or
> 99
flooding.
95
95 • This System has been tested according to NSF/ANSI 42, 53
95
and 401 for the reduction of the substances listed below. The
>99
concentration of the indicated substances in water entering the
95.5
95.9
permissible limit for water leaving the system, as specified in
98.6
NSF/ANSI 42, 53 and 401.
98.6
98.7
96.1
96.6
98.1
98.1
96
95.9
96.5
97.1
99.1
97.3
0.5 gpm (1.89 lpm)
Potable Water
25-120 psi (172-827 kPa)
33°F-100°F (0.6°C-38°C)
170 gallons (643.5 liters)
XWF - XWFE. For estimated costs
To reduce the risk associated with
ingestion of contaminants:
XWF System is certified by IAPMO R&T
against NSF/ANSI Standards 42,53, and 401
for the reduction of claims specified on the
performance data sheet and at iapmort.org.