Tabla de contenido
Publicidad
Certificate No:
Date of Issue:
Manufacturer:
Additional Manufacturing location(s):
This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and found to comply with the
IEC Standard list below and that the manufacturer's quality system, relating to the Ex products covered by this certificate, was assessed and
found to comply with the IECEx Quality system requirements. This certificate is granted subject to the conditions as set out in IECEx Scheme
Rules, IECEx 02 and Operational Documents as amended.
STANDARDS:
The apparatus and any acceptable variations to it specified in the schedule of this certificate and the identified documents, was found to comply
with the following standards:
IEC 60079-0 : 2011
Edition:6.0
IEC 60079-1 : 2014-06
Edition:7.0
IEC 60079-31 : 2013
Edition:2
IEC 60079-7 : 2015
Edition:5.0
This Certificate does not indicate compliance with electrical safety and performance requirements other than those expressly included in the
TEST & ASSESSMENT REPORTS:
A sample(s) of the equipment listed has successfully met the examination and test requirements as recorded in
Test Report:
IT/EUT/ExTR14.0001/02
Quality Assessment Report:
IT/EUT/QAR14.0001/03
IECEx EUT 14.0001X
2019-02-08
ORANGE1 ELECTRIC MOTORS S.p.A.
Via Mantova, 93
43122 Parma
Italy
Explosive atmospheres - Part 0: General requirements
Explosive atmospheres - Part 1: Equipment protection by flameproof enclosures "d"
Explosive atmospheres - Part 31: Equipment dust ignition protection by enclosure "t"
Explosive atmospheres – Part 7: Equipment protection by increased safety ''e''
Standards listed above.
IECEx Certificate
of Conformity
Issue No: 2
Page 2 of 4
Publicidad
Tabla de contenido
