Tabla de contenido
Publicidad
BATTERY INFORMATION
CAUTION:
•
Be sure to insert the batteries
correctly and always follow the
toy and battery manufacturers'
instructions.
•
Do not mix old and new
batteries or alkaline, standard
(carbon-zinc) or rechargeable
(nickel-cadmium) batteries.
Only batteries of the same or
equivalent type recommended
should be used.
•
Always remove weak or dead
batteries from the product;
do not short-circuit supply
terminals.
•
Insert batteries with correct
polarity (+/-) as shown.
+
-
MicroPower
™
Motor
Toy will go in the direction of the arrow on top of the
Motor. Wind until you hear clicking. Then release.
Do not overwind.
Important Tips
•
Alkaline batteries are recommended.
•
Rechargeable batteries are not recommended.
•
Remove rechargeable batteries from toy
before charging; they must be charged only
under adult supervision.
•
Non-rechargeable batteries must not be
recharged.
•
Keep components free of dust; do not immerse
or use in water.
•
Do not dispose of batteries in a fire; they could
leak or explode and cause injury.
•
Remove all batteries if the toy will not be used
for a long period of time.
•
Do not put Rods smaller than 2 inches in any
openings of the motor; they will damage the
motor, and cannot be removed.
How to Insert and Remove
Batteries
Use a small Phillips head screwdriver to loosen
the screw. Insert 2 fresh AA batteries (LR6)
into the compartment with the correct polarity
(+/-) as shown here.
PARTS LIST
Before you start building, be sure to compare
the parts in your set with the parts listed here.
If anything is missing, check out the back cover
of this instructions booklet for how to contact us.
We're here to help!
3
3
Publicidad
Tabla de contenido
