Disclaimer; Maintenance And Care; Federal Communications Commission (Fcc) Statement - Xplova NOZA S Guia De Inicio Rapido

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 114
4. When the Xplova NOZA S is not in use, make sure not to expose it to direct
sunlight for long periods of time.

Disclaimer

Attention! Xplova shall not be held responsible for temporary or permanent injury to
the user out of using the Xplova NOZA S (either directly or indirectly).

Maintenance and care

1. When cleaning the bike trainer, please use neutral lubrication oil. DO NOT use
corrosive detergents.
2. DO NOT burnish the surface of the bike trainer or drill holes. Scratches or drilled
holes will lead to occurrence of cracks.
3. Please place the bike trainer indoors and keep it dry to avoid damage from
humidity.

Federal Communications Commission (FCC) Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the
-
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
-
This device complies with radio frequency (RF) exposure limits adopted by the
Federal Communications Commission for an uncontrolled environment. This
equipment should be installed and operated to ensure a minimum of 20 cm spacing to
any person at all times.
Safety precautions and regulations
EN-11

Publicidad

Tabla de contenido
loading

Tabla de contenido