Safety Information - BGS technic 62666 Manual De Instrucciones

SAFETY INFORMATION

•
Do not use the tool if parts are missing or damaged.
•
Use the tool for the intended purpose only.
•
Never place the tool on the vehicle battery. There is a risk of a short circuit.
•
Be careful when working with the engine running. Loose clothing, tools and other objects can be
caught by rotating parts and cause serious injury.
•
Keep children and other unauthorized persons away from the work area.
•
Be careful when working on hot engines because of the risk of burn injuries.
•
If you remove the ignition key before repairing, you can prevent the engine from being started
accidentally and resulting in engine damage.
•
This manual serves as a brief guide and does not replace a workshop manual. Always refer to the
vehicle-specific service literature, particularly the technical data such as torque values and
instructions for disassembly/assembly, etc.
•
After repair or before starting the engine, turn a minimum of 2 turns by hand and check the timing
again.
•
Turn the engine only in the normal direction of rotation (clockwise unless otherwise specified)
APPLICATION
Engine
1.2 16V
176B9.000
182B2.000
188A5.000
1.4 16V
843A1.000
1.4 16V
169A3.000
1.4 16V
192B2.000
198A1.000
198A4.000
199A6.000
199A8.000
USE
Crankshaft setting tool (piston height gauge)
These Tools are used to adjust the
by indicating when all four pistons are in line with each other.
Carefully insert the Piston Height Gauge tools into No.1 and No.2 and
screw in fully (tighten to 5Nm).
NOTE: Some engine codes like 192B2.000, 198A1.000, 198A4.000
and 199A6.000 use of No.3 and No.4 cylinders.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Crankshaft Camshaft
setting tool setting tool
X (x2) X (x2)
X X (X2)
X (x2) X (x2)
correct crankshaft timing position
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Tensioner Camshaft
adjusting tool locking tool
X
X
X
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
X
X