Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Frame Rail
Receiver Shown In Proper Position
Hitch Requires 5/8" Pin and Clip
Equipment Required:
Fastener Kit: F65041
Wrenches: 3/4", 18mm, 19mm
Drill Bits: 11/16"
Enlarge Existing Hole
1
Qty. (2)
Hex Bolt, 1/2"-13 x 1-1/2"
2
Qty. (4)
Hex Bolt, M12 x 1.25 x 40
1.
Remove tow hooks from vehicle if present and return to customer.
2.
Enlarge two (2) existing holes in frame rail using a 11/16" drill.
3.
To install rivet nut in frame rail, hold hitch tight against frame rail while tightening the 1/2"-13 hex bolt, conical toothed washer & rivet nut
to 50 lb-ft (68 N-m). This will seat the rivet nut.
4.
Raise receiver into position and install four (4) M12 bolts and conical washers.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. A hitch or ball which has been damaged should be removed and replaced.
Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. Do not cut, weld, or
modify hitch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2005 Cequent Towing Products
Front Mounted Receiver
Installation Instructions
Toyota Tacoma
Fascia
Existing Weldnuts
Frame Rail
Tighten all M12 CL10.9 fasteners with torque wrench to 92 Lb.-Ft (125 N-m).
Tighten all 1/2" GR5 fasteners with torque wrench to 50 Lb.-Ft (68 N-m).
CARGO CAPACITY – DO NOT EXCEED
500 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
9000
3
Qty. (6)
Conical Washer, 1/2"
4
Qty. (2)
Rivet Nut
Sheet 1 of 3
N65041
Part Numbers:
65041
LB. MAX. WINCH LINE PULL
11-07-05
Rev. B
Publicidad
Manuales relacionados para Cequent Towing Products 65041
Resumen de contenidos para Cequent Towing Products 65041
- Página 1 This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. Sheet 1 of 3 N65041 11-07-05 Rev. B 2005 Cequent Towing Products...
- Página 2 Ne pas découper, souder ni modifier l’attelage. Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage Feuille 2 de 3 N65041 11-07-05 Rev. B 2005 Cequent Towing Products...
- Página 3 Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York, V.E.S.C. Regulación V-5 y SAE J684. Hoja 3 of 3 N65041 11-07-05 Rev. B 2005 Cequent Towing Products...