Cequent Towing Products 65048 Instrucciones De Instalación

Receiver Shown In Proper Position
Equipment Required:
Fastener Kit: 65048F
Wrenches: 10mm, 15mm, T-45 or T-55
Drill Bits: None
Remove
Existing Fasteners
Qty.
1
Hex Bolt, 1/2"-13 x 1-3/4"
(4)
Qty.
2
Conical Washer, 1/2"
(4)
Qty.
3
Spacer, 1-1/2" x 2" x 1/4", Painted Black
(2)
Qty.
4
Spacer, 1-1/2" x 2" x 1/4", Zinc Plated
(2)
1. Remove, if present, plastic shield, OEM tow hooks, and upper bumper bolts.
2. See proper figure for fastener installation.
3. If desired, trim and reattach plastic shield. CONSULT VEHICLE OWNER BEFORE TRIMMING.
NOTE: DO NOT REATTACH TOW HOOKS.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body
panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety
precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.
Regulation V-5 and SAE J684.
2006 Cequent Towing Products
z
Front Mounted Receiver
Installation Instructions
Jeep Wrangler
Bumper
Recovery
Eye
FIGURE 1
1997 And Later
Tighten all 1/2" GR5 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
Tighten all M10 CL10.9 fasteners with torque wrench to 50 Lb.-Ft (68 N-m).
CARGO CAPACITY – DO NOT EXCEED
300 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
9000
Existing Fasteners
Qty.
5
Hex Bolt, M10 x 1.50 x 45
(2)
Qty.
6
Conical Washer, 3/8"
(2)
Qty.
7
Flat Washer, 7/16"
(6)
Sheet 1 of 3 65048N
Part Numbers:
65048
LB. MAX. WINCH LINE PULL
Remove
FIGURE 2
1987 Through 1996
2-17-06 Rev. A