Cequent Towing Products 65046 Instrucciones De Instalación

Frame Rail
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 65046F
Wrenches: 18mm, 3/4" Sockets
Drill Bits: 1/2", 1-1/4" Hole Cut Saw
Frame Rail
Existing 12mm
Hex Flange Nut
Both Sides
1
Qty. (2) Spacer, 2" x 2" x 1/4"
2
Qty. (2) Spacer, 1.88" sq. x .179"
3
Qty. (4) Carriage Bolt, 1/2" X 1-1/2"
4
Qty. (4) Spacer, 1" x 2" x 1/4"
1. Support the front bumper during this operation. Loosen four 12mm hex nuts, two on each side, holding the bolt brackets onto
the frame as shown in Figure 1. Remove the bottom nuts completely and back out bolt brackets without completely removing
them.
2. Place spacers (1) over lower bolts on bolt brackets on each side of the frame and raise the hitch into position as show in
Figure 1. In the case where the vehicle does not have tow loops, use the optional spacers (2) as shown in Figure 2.
3. Fasten the existing 12mm hex nuts that were removed in Step 1 onto the lower bolts on the bolt brackets. Tighten 12mm hex
nuts snugly while ensuring that the hitch side brackets are touching the bottom of the frame.
4. Using the hitch as a template, drill four 1/2" holes in the underside of the frame.
5. Drill two 1-1/4" access holes on the inside of each frame.
6. Use a pull wire (7) to feed a spacer (4) and carriage bolt (3) into each of the four drilled holes as shown in Figure 3.
7. Fasten the carriage bolts in place with conical washers (5) and hex nuts (6). Tighten all nuts with a torque wrench.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2005 Cequent Towing Products
Installation Instructions
Dodge Ram 2500, 3500, Front Mount Receiver
Fascia
Existing
Bolt Bracket
Both Sides
Access Hole
Both Sides
Drill Holes
Tighten all 12mm Cl8.8 fasteners with torque wrench to 68 Lb.-Ft.
Tighten all 1/2" GR5 fasteners with torque wrench to 75 Lb.-Ft.
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
9,000 LB Max Winch Line Pull
500 LB Cargo Capacity or Vehicle Front
Gross Axle Weight Rating (GAWR)
Figure 1
5
Qty. (4) Conical Washer, 1/2"
6
Qty. (4) Hex Nut, 1/2"
7
Qty. (2) Pull Wire
Sheet 1 of 1 65046N
Part Numbers:
65046
Figure 2
Figure 3
07-21-05 Rev. B