Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT NOTE! The lower part of the bumper air dam requires
trimming to install hitch. Consult with vehicle owner before proceeding
with installation.
1. Trim Air Dam - Mark a 3" wide x 3-1/4" tall area in the center of
lower air dam. Using a utility knife, carefully trim the air dam.
3-1/4"
3. Install fasteners into C-shaped Cross Member - Using the 7/16 pull wire
provided, install the 7/16 carriage bolts & special washers into the existing
holes in the cross member. Leave pull wires attached temporarily.
©2016 Cequent™ Performance Products, Inc. -
3"
Printed in Mexico
2. Loosen Splash Guard - Remove the (2) rearmost M10 bolts from plastic
splash guard. Do not remove the (2) forward bolts.
4. Install hitch forward attachments - Raise hitch into position, feed the pull
wires through the slots in hitch, pull the carriage bolts through holes in
cross member and hitch. While holding the thread of carriage bolt,
remove the pull wire and loosely install the 7/16" conical washer and hex
nut on the carriage bolt, both sides.
Sheet 4 of 15
65071N
2-22-16
Rev. A
Publicidad
