Light Kit Assembly - Craftmade Cavalier CAV52 Guia De Instalacion

10. Light Kit Assembly.

Remove 1 screw from fitter plate (on the
underside of the motor housing) and loosen
the other 2 screws.
Connect WHITE wire from light kit fitter to
WHITE wire from motor housing. Connect
BLACK wire from the light kit fitter to BLACK
(or BLUE) wire from the motor housing. Be
sure that the molex connections snap
together securely.
Align slotted holes in light kit fitter with
loosened screws on fitter plate; twist light kit
fitter to lock. Re-install screw that was
previously removed and then securely tighten
all 3 screws.
Install 3 medium base 6.5 watt LED bulbs
(included).
Important: When replacing bulbs, please allow
bulbs and glass shade to cool down before
touching.
Align hole in glass shade with threaded rod on
light kit fitter and push up gently until
threaded rod comes through hole. Align hole
in center of finial plate with threaded rod and
push up. Secure glass shade with finial. Do NOT
overtighten finial as glass may crack or break.
fitter plate
bulb
threaded
rod
finial plate
page 9
motor housing
molex connections
light kit fitter
glass shade
finial