Driving Instructions And Maintenance - Quicke Q 900 Serie Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 129
DRIVING INSTRUCTIONS AND MAINTE-
NANCE
For maximum stability and to avoid skidding, always
carry implement with load as low as possible.
When driving the implement into the material to be
handled, always make sure that the valve is in a neutral
position, otherwise the front of the tractor tends to rear
at the moment of drive-in, which would entail strains on
both loader and tractor. Keep to the following rules:
NEVER drive at full speed into the material. Select a low
gear for the best traction.
COUNTER WEIGHT: For overloading and safety
reasons, always use counter-balance with weights when
carrying heavy materials or implements with large out-
reach.
See safety instructions, page 105.
Do not leave the tractor with the loader in "lift" position
and do not stand beneath the load.
When changing implements, always check that the
implement is properly locked in position by pressing the
front end of the implement to the ground.
OPERATING
Applies to loaders with separate control valve
(ERGO DRIVE).
For loaders with ELECTRO-hydraulic mono lever remote
control (ELECTRO DRIVE), see the separate instruction
for this equipment !
1
ENGLISH (118-501)
The control device (MONO-lever) has the following
functions:
Lever Movement:
Backwards -
Forwards
Left ** -
Right **
*The floating function is engaged when the control
device is brought maximally forwards. The lever should
then stay in this position. By moving the lever in the
reverse direction, the function will be disengaged.
** Concerns right-hand mounted control device. As
regards the left-hand mounted control device, the
reversed lever movement is obtained by shifting the
hydraulic hoses marked yellow-red. See the instruction
supplied with the hydraulic kit.
Safety Locking Device: The control device is equipped
with a safety lock, see fig.1, which, in locking position
(left), prevents involuntary operation.
Selecto (applies to loaders equipped with electric switch
valves)
The lever knob is equipped with two switches acc. to
fig.2.
Function
Control lever in operating position for implement func-
tion.
Push button (A) = Valve (3rd) in function
Push button (C) = Valve (4th) in function
Remark
If hydraulic implement locking is fitted, see the instruc-
tions for this equipment.
2
118
Loader beam is lifted
-
Lowering of loader beam + floating
position*
The implement is crowded
-
The implement is dumped

Publicidad

Tabla de contenido
loading

Tabla de contenido