Quicke Q 900 Serie Manual Del Operador página 8

LOADERS
Fitting
Check that the marking on the accessory boxes
correspond to the marking on the loader / the subframe.
Except specifying details about the tractor model, the
decal on the accessory box for the subframe also
specifies the number of packages included in the kit as
well as the part numbers - Check this information.
Read the instructions supplied with each kit before
attaching the loader.
Install the subframe and connect the valve or hose kit of
the loader to the hydraulic system of the tractor in
accordance with the mounting instruction.
Lift the loader on to the subframe. There are holes for
the lifting hooks inside the knee plates (see fig.1)
Install the retaining forks acc. fig.2(A) and tighten the
screws (B).
Pass the hydraulic hoses through the U-bolt under the
beam according fig.3.
1
5
ENGLISH (107-501)
Connect the hoses to the valve (if there is one mounted)
according to the colour marking (fig.4).
WARNING : always install the loader valve with a return
hose to tank. If this hose is exposed to pressure, the
valve will get damaged.The beam will lift when the
control lever is moved backwards.
Install the level indicator (fig.5) on the implement ram.
Adjustments are made with an implement attached. The
level indicator can be installed on either side, left or right.
2
3
4
107