Repair Instructions; To Clean And Examine The Product Parts; To Change A Trimmer Line Cutter; To Replace The Trimmer Head - RedMax BTR250PL Manual De Taller

5.1 To clean and examine the product parts

• Clean and examine all parts fully. You find more
instructions in the chapter for each part if special
tools or procedures are necessary.
• Replace damaged or defective parts.
• Always use original spare parts.

5.2 To change a trimmer line cutter

Always replace a worn trimmer line cutter with a new
one.
1. Loosen the 2 screws and replace the trimmer line
cutter on each side.
572 - 001 - 28.03.2018

5 Repair instructions

5.3 To replace the trimmer head

Note: To increase the life of the cord it can be soaked in
water for a couple of days before it is assembled. This
will make the cord tougher.
1. Press the snap-in clips on the trimmer head and
remove the trimmer head and trimmer line.
2. Pull out the line chute assembly.
3. Remove the nut that holds the trimmer head and the
drive disc.
4. Replace the trimmer head.
5. Install the nut.
6. Install the line chute assembly.
7. Install the trimmer head.
Repair instructions - 7