To Replace The Handle; To Replace The Shaft; To Repair Damaged Threads; To Change Trimmer Line - RedMax BTR250PL Manual De Taller

5.6 To replace the handle

1. Loosen the the 2 screws and remove the parts from
the shaft.
2. Assemble in opposite sequence.

5.7 To replace the shaft

1. Disassemble the handle and the operating handle.
To disassemble the operating handle on page
See
14
2. Disassemble the wear guard below the battery
To disassemble and assemble the
housing. See
battery housing wear guard on page 13
3. Disassemble the battery housing. See
disassemble the battery housing on page 14
4. Disassemble the trimmer cord guard. See
disassemble the trimmer guard on page 13
5. Disassemble the motor. See
motor on page 9
6. Loosen the 4 screws and the plate holding the shaft.
7. Replace the shaft and the plate if necessary and
screw on the battery housing.
8. Assemble the product in opposite sequence.

5.8 To repair damaged threads

1. If the plastic threads in the chassis are damaged,
make a hole with a 4.5 mm drill bit.
2. Replace the original screw with the screw 503 21
74-16 - IHSCT MT5x16.
572 - 001 - 28.03.2018
To
To
To disassemble the

5.9 To change trimmer line

T25B
1
2
4
5
6 7
15 cm
6"
9

5.10 Motor

5.10.1 To disassemble the motor
1. Disassemble the trimmer head. See
trimmer head on page 7 .
2. Dismantle the trimmer guard.See
the trimmer guard on page 13 .
3. Dismantle the operating handle. See
disassemble the operating handle on page 14 .
4. Dismantle the wear guard under the battery housing.
To disassemble and assemble the battery
See
housing wear guard on page 13 .
3
6,0 m
18'
10 cm
4"
3,05 m
9'
8
"Click"
To replace the
To disassemble
To
Repair instructions - 9