D End Panel Position - ubabub Pod Instrucciones

D
End panels position
step 1 Insert Support Pins into the side panels as per the diagram.
step 2 Select Lower Curved End, using the edge of the plastic base as a guide, slide
Curved End horizontally until it joins tightly against side panel.
step 3 Starting with the center hole, using 60mm bolts attach end to base –
finger tighten only.
step 4 Insert left and right bolts (using 55mm bolts), finger tighten only.
step 5 Once all three bolts are in place, check alignment and tighten with allen Key
Please note: Do not over-tighten.
step 6 Select three Connecting Pins and install into top of Lower Curved End as per
diagram using screw driver.
step 7 repeat steps 2–6 on other side.
6 x
Connector
Pin
4 x
55mm
bolt
8 x
Support
Pin
2 x
60mm
bolt
11