IRUDEK 96791 Manual De Instrucciones página 12

RIFERIMENTO
NUMERO DI SERIE
ANNO DI PRODUZIONE
COMPATIBILE CON
DATA DI ACQUISTO
DATA DEL PRIMO UTILIZZO
NOME DELL'UTILIZZATORE
COMMENTI
DATA OGGETTO
(Revisione
Periódica/Riparazione)
Organismo notificato che ha effettuato l'esame CE di tipo : AITEX, Instituto Tecnológico Textil, Plaza Emilio Sala 1,
03801 Alcoy, Spagna (Organismo notificato numero 0161 ) e organismo notificato che interviene nella fase di
controllo della produzione: AITEX, Instituto Tecnológico Textil, Plaza Emilio Sala 1, 03801 Alcoy, Spagna
(Organismo notificato numero 0161 ).
CAREFULLY READ THE INSTRUCTIONS BEFORE USING THE ENERGY ABSORBER
The energy absorbers Irudek are classified as PPE (Personal Protective Equipment) by the European
Regulation EU 2016/425
The declaration of conformity is available at the following internet address:
http://www.irudek.com/es-es/descargas/
DESCRIPTION
The energy absorber is a component or element of a fall arrest system, designed to dissipate kinetic energy during
a fall from a certain height.
The energy absorbers are used with either a lanyard, an anchor line or a full body harness or combined with any of
them.
The combination of an energy absorber and a lanyard is a subsystem that when connected to a full body harness
according to EN 361, constitutes one of the fall arrest systems specified in the Norm EN 363.
APPLICATION
The use of the energy absorber with a fall arrest subsystem must be compatible with the operating instructions for
each component of the system and the Norms: EN 353-1, EN 353-2, EN 354, EN 361, EN 362.
USE
The energy absorber has two thimbles, stitched one at each end, used as connecting points to a fall arrest system.
Can be used in the following ways:
- Energy absorber with rope lanyard :
The energy absorber can be permanently incorporated to a rope lanyard, but only by the manufacturer. However,
the user can connect the energy absorber to the rope lanyard using connectors according to EN 362.
- Energy absorber with full body harness:
The energy absorber can be permanently incorporated to a full body harness, with a loop directly stitched to the
harness anchor point, but only by the manufacturer. However, the user can connect the energy absorber to the full
body harness using connectors according to EN 362.
- Energy absorber with fall arrester:
SCHEDA TECNICA
VERIFICATORE
Nome
INSTRUCTION MANUAL
ENERGY ABSORBER IRUDEK
and are in conformity to the European Norm EN 355:2002 (energy absorbers).
COMMENTI
+ Firma
PROSSIMA
DATA DI
Revisione
GB
PPE