Publicidad

Idiomas disponibles

Idiomas disponibles

Cequent
Performance Products, Inc.
Website: www.cequentgroup.com
Technical Assistance: 800-632-3290
TechnicalSupport@cequentgroup.com
To prevent SERIOUS INJURY, DEATH or PROPERTY DAMAGE:
ALWAYS read, understand and follow warnings and instructions
for your hitch BEFORE installation. Keep for future reference.
DO NOT cut, weld or modify this receiver.
CHECK all fasteners are tight and your hitch is securely mounted
to your vehicle periodically.
ALWAYS read, understand and follow all warnings and
instructions for your vehicle and for other accessories you will use
with your hitch BEFORE use.
LOAD the trailer heavier in front.
DO NOT exceed lower of towing vehicle manufacturer's rating or:
Hitch Type
Max Gross Trailer
Weight Carrying
2000 lb. (908 kg)
Weight Distributing
ALWAYS wear your seatbelt.
SLOW DOWN when towing, NEVER exceed any posted speed limit.
If EXCESS SWAY occurs, take your foot off the gas pedal and hold
the steering wheel as steady as possible. DO NOT apply your
brakes and DO NOT speed up.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 24945, 77332, CQT24945
Max Tongue
Weight
Weight
200 lb. (90.8 kg)
X
X
LIMITED LIFETIME WARRANTY
1.
Limited Lifetime Warranty ("Warranty"). Cequent Performance Products, Inc. ("We",
"Us" or "Our") warrants to the original consumer purchaser only ("You" or "Your") that the
product will be free from material defects in both material and workmanship, ordinary wear
and tear excepted. The Warranty is valid only if (a) the products are returned to Us for
inspection and testing; (b) Our inspection discloses to Our satisfaction that any alleged
nonconformance are material and have not been caused by misuse, neglect, wear and tear,
improper installation, unsuitable storage, improper repair, alteration, or accident; and (c) the
products were installed, maintained and used in accordance with Our instructions. THE
WARRANTY IS MADE IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR
IMPLIED (OTHER THAN THE WARRANTY OF TITLE AS PROVIDED BY THE
UNIFORM COMMERCIAL CODE IN EFFECT IN MICHIGAN), INCLUDING
WITHOUT LIMITATION, ANY WARRANTIES OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE, SAID WARRANTIES BEING EXPRESSLY
DISCLAIMED.
2.
Obligations of Purchaser. To make a Warranty claim, contact Us at our principal address of
47912 Halyard Drive, Suite 100, Plymouth, MI 48170, 1-800-632-3290, identify the product
by model number, and follow the claim instructions that will be provided. Any returned
product that is replaced by Us becomes our property. You may be responsible for return
shipping costs. Please retain your purchase receipt to verify date of purchase and that You
are the original consumer purchaser. The product and the purchase receipt must be provided
to Us in order to process Your Warranty claim.
3.
Exclusive Remedy. Product replacement is Your sole and exclusive remedy under this
Warranty. We shall not be liable for service or labor charges incurred in removing or
replacing a product. IN NO EVENT WILL WE BE RESPONSIBLE FOR ANY INDIRECT,
SPECIAL, CONSEQUENTIAL OR PUNITIVE DAMAGES.
4.
Assumption of Risk. You acknowledge and agree that any use of the product for any
purpose other than the specified use(s) stated in the product instructions is at Your own risk.
5.
Governing Law. This Warranty gives You specific legal rights, and You also may have
other rights which vary from state to state. This Warranty is governed by the laws of the
State of Michigan, without regard to rules pertaining to conflicts of law. The state courts
located in Oakland County, Michigan shall have exclusive jurisdiction for any disputes
relating to this Warranty.
Rev 9/2014
Sheet 1 of 21
Scan for safe
towing tip, or visit
http://www.ceque
ntgroup.com/qr-
product.aspx
24945NP
4-26-16
Rev. A

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Cequent Performance Products 24945

  • Página 1 TechnicalSupport@cequentgroup.com LIMITED LIFETIME WARRANTY Limited Lifetime Warranty (“Warranty”). Cequent Performance Products, Inc. ("We", “Us” or “Our”) warrants to the original consumer purchaser only ("You" or “Your”) that the To prevent SERIOUS INJURY, DEATH or PROPERTY DAMAGE: product will be free from material defects in both material and workmanship, ordinary wear •...
  • Página 2: Installation Instructions

    ™ Cequent Performance Products, Inc. Installation Instructions Website: www.cequentgroup.com PART NUMBERS: 24945, 77332, CQT24945 Technical Assistance: 800-632-3290 TechnicalSupport@cequentgroup.com Applications: Installation Time: 50 min Years Make Models The time listed above is the average time for professional installers. If you do not...
  • Página 3 Installation Instructions 8-1/4” 2” PART NUMBERS: 24945, 77332, CQT24945 2” 3” Always wear SAFETY GLASSES Bumper end panel when installing hitch Heat shield (trimmed) Trim 4-1/2” Figure 2 Both Sides (Sold separately) Bumper beam Drawbar Kit: 3593 Electronic sensor Drawbar must be...
  • Página 4 1. Remove (2) plastic underbody panels – using an 8mm socket, 2. Remove taillights – Open trunk. Using a flat head screw driver, remove (5) screws and a 10mm socket, remove (1) plastic nut from remove (1) plastic screw from each panel covering the taillight mounting hardware.
  • Página 5 3c. Remove fascia - using a 10mm socket, remove (2) screws from 3d. Remove fascia - using a plastic trim panel tool, gently remove the plastic fascia starting at the outer edges. top of fascia near trunk, (1) per side. 5.
  • Página 6 7. Trim heat shield – using a tape measure, marker, & tin snips, mark 6. Remove heat shield – using an 8mm socket remove (4) screws and & trim rear heat shield as shown in figure 2. a 10mm socket, remove (3) hex nuts from rear heat shield. 8-1/4”...
  • Página 7 12. Reinstall heat shield – reinstall trimmed heat shield. 11. Reinstall rear sensor – if equipped, reinstall the rear sensor and reconnect the wiring. Heat shield (trimmed) 14. Reinstall (2) plastic underbody panels – reinstall the (2) plastic 13. Reinstall fascia and taillights – reinstall fascia, taillights, and (2) underbody panels and reattach the wiring clips to panel on driver’s side.
  • Página 8: Garantie À Vie Limitée

    GARANTIE À VIE LIMITÉE Garantie à vie limitée (« Garantie »). Cequent Performance Products, Inc. (« Nous », « Notre ») garantit à l’acheteur initial seulement (« Vous », « Votre ») que le produit sera Pour prévenir les blessures SÉVÈRES, FATALES ou les DOMMAGES exempt de vices de matières et de fabrication, exception faite de l’usure normale.
  • Página 9 ™ Cequent Performance Products, Inc. Instructions d’installation Site Internet: www.cequentgroup.com NUMÉROS DE PIÈCES : 24945, 77332, CQT24945 Assistance technique: 800-632-3290 TechnicalSupport@cequentgroup.com Applications : Durée de l'installation : 50 min Années Marque Modèles La valeur indiquée ci-dessus est la durée moyenne des installeurs professionnels.
  • Página 10 Instructions d’installation 8-1/4” 2” NUMÉROS DE PIÈCE : 24945, 77332, CQT24945 2” 3” Toujours porter des LUNETTES DE PROTECTION lors de l'installation de Panneau d'extrémité l'attelage. du pare-chocs Écran thermique (découpé) Découper des 4-1/2” Figure 2 deux côtés (Vendu séparément)
  • Página 11 Enlever les feux arrière – Ouvrir le coffre. À l'aide d'un tournevis à lame Enlever deux (2) panneaux de soubassement en plastique – À l'aide plate, retirer une (1) vis en plastique de chaque panneau recouvrant la d'une douille 8 mm, retirer cinq (5) vis, et avec une douille 10 mm, retirer un (1) quincaillerie de montage des feux arrière.
  • Página 12 Enlever le carénage - À l'aide d'une douille 10 mm, retirer deux (2) vis . Enlever le carénage - À l'aide d'un écarteur de panneau en plastique, dans le haut du carénage près du coffre, une (1) par côté. retirer avec précaution le carénage en plastique en commençant par les bords extérieurs.
  • Página 13 Découper l'écran thermique – À l'aide d'un ruban à mesurer, d'un Enlever l'écran thermique – À l'aide d'une douille 8 mm, retirer quatre (4) marqueur et d'une cisaille, marquer et découper l'écran thermique arrière vis, et avec une douille 10 mm, retirer trois (3) écrous hexagonaux de l'écran comme illustré...
  • Página 14 11. Réinstaller le capteur arrière – S'il est présent, réinstaller le capteur Réinstaller l'écran thermique – Réinstaller l'écran thermique découpé. arrière et rebrancher le câblage. Heat shield (trimmed) Réinstaller le carénage et les feux arrière – Réinstaller le carénage, les Réinstaller deux (2) panneaux de soubassement en plastique –...
  • Página 15: Garantía Limitada De Por Vida

    CQT24945 GARANTÍA LIMITADA DE POR VIDA Garantía limitada de por vida ("Garantía") Cequent Performance Products, Inc. ("nosotros", Para evitar DAÑOS DE GRAVEDAD, A LA PROPIEDAD O LA MUERTE: "nos" o "nuestro/a/s") garantiza al comprador original únicamente ("usted" o "su/s") que el producto estará...
  • Página 16: Equipo Necesario

    ™ Cequent Performance Products, Inc. Instrucciones de instalación Sitio web: www.cequentgroup.com NÚMEROS DE PARTES: 24945, 77332, CQT24945 Assistance técnica: 800-632-3290 TechnicalSupport@cequentgroup.com Aplicaciones: Tiempo de instalación: 50 min Años Marca Modelos El tiempo indicado anteriormente es el tiempo promedio para instaladores...
  • Página 17 Instrucciones de instalación 8-1/4” 2” NÚMEROS DE PARTE: 24945, 77332, CQT24945 2” 3” Siempre usar GAFAS DE SEGURIDAD Panel lateral del al instalar el enganche parachoques Protector de calor (recortado) Recortar 4-1/2” Figura 2 Ambos lados (Se vende por separado) Travesaño del parachoques...
  • Página 18 Quitar las luces traseras: Abrir el maletero. Con un destornillador de cabeza plana, Quitar (2) paneles plásticos inferiores de la carrocería: Con una llave de 8 mm, quitar (5) tornillos y con una llave de 10 mm, quitar (1) tuerca de plástico de los paneles quitar (1) tornillo de plástico de cada panel que cubre las piezas de instalación de la luz inferiores, en ambos lados.
  • Página 19 Quitar la fascia: con una llave de 10 mm, quitar (2) tornillos de la parte Quitar la fascia: Con una herramienta de recortar paneles plásticos, superior de la fascia cerca del maletero, (1) por lado. quitar con cuidado la fascia plástica empezando desde los bordes exteriores.
  • Página 20 Recortar protector de calor: Con una cinta métrica, marcador y tijeras para Quitar el protector de calor: Con una llave de 8 mm, quitar (4) tornillos y cortar metal, marcar y recortar el protector de calor trasero, como se muestra una llave de 10 mm, quitar (3) tuercas hexagonales del protector de calor en la Figura 2.
  • Página 21 11. Reinstalar el sensor trasero: Si viene equipado, reinstalar el sensor Reinstalar el protector de calor: Reinstalar el protector de calor trasero y volver a conectar el cableado. recortado. Heat shield (trimmed) Reinstalar (2) paneles plásticos inferiores de la carrocería: Reinstalar Reinstalar la fascia y las luces traseras: Reinstalar la fascia, las luces (2) paneles plásticos inferiores de la carrocería y volver a colocar las traseras y (2) paneles de plástico cerca de maletero.

Este manual también es adecuado para:

77332Cqt24945

Tabla de contenido