Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Cequent
Performance Products, Inc.
www.cequentgroup.com
Technical Assistance:
TechnicalSupport@cequentgroup.com
To prevent SERIOUS INJURY, DEATH or PROPERTY DAMAGE:
ALWAYS read, understand and follow warnings and instructions
for your hitch BEFORE installation. Keep for future reference.
DO NOT cut, weld or modify this receiver.
CHECK all fasteners are tight and your hitch is securely mounted
to your vehicle periodically.
ALWAYS read, understand and follow all warnings and
instructions for your vehicle and for other accessories you will use
with your hitch BEFORE use.
LOAD the trailer heavier in front.
DO NOT exceed lower of towing vehicle manufacturer's rating or:
Hitch Type
Max Gross Trailer
Weight Carrying
7700 lb. (3496 kg)
Weight Distributing
ALWAYS wear your seatbelt.
SLOW DOWN when towing, NEVER exceed any posted speed limit.
If EXCESS SWAY occurs, take your foot off the gas pedal and hold
the steering wheel as steady as possible. DO NOT apply your
brakes and DO NOT speed up.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
Installation Instructions
800-632-3290
PART NUMBERS: 76076, 84076, CQT76076
Max Tongue
Weight
Weight
770 lb. (349 kg)
N/A
N/A
LIMITED LIFETIME WARRANTY
Limited Lifetime Warranty ("Warranty"). Cequent Performance Products, Inc. ("We",
1.
"Us" or "Our") warrants to the original consumer purchaser only ("You" or "Your") that the
product will be free from material defects in both material and workmanship, ordinary wear
and tear excepted. The Warranty is valid only if (a) the products are returned to Us for
inspection and testing; (b) Our inspection discloses to Our satisfaction that any alleged
nonconformance are material and have not been caused by misuse, neglect, wear and tear,
improper installation, unsuitable storage, improper repair, alteration, or accident; and (c) the
products were installed, maintained and used in accordance with Our instructions. THE
WARRANTY IS MADE IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR
IMPLIED (OTHER THAN THE WARRANTY OF TITLE AS PROVIDED BY THE
UNIFORM COMMERCIAL CODE IN EFFECT IN MICHIGAN), INCLUDING
WITHOUT LIMITATION, ANY WARRANTIES OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE, SAID WARRANTIES BEING EXPRESSLY
DISCLAIMED.
2.
Obligations of Purchaser. To make a Warranty claim, contact Us at our principal address of
47912 Halyard Drive, Suite 100, Plymouth, MI 48170, 1-800-632-3290, identify the product
by model number, and follow the claim instructions that will be provided. Any returned
product that is replaced by Us becomes our property. You may be responsible for return
shipping costs. Please retain your purchase receipt to verify date of purchase and that You
are the original consumer purchaser. The product and the purchase receipt must be provided
to Us in order to process Your Warranty claim.
3.
Exclusive Remedy. Product replacement is Your sole and exclusive remedy under this
Warranty. We shall not be liable for service or labor charges incurred in removing or
replacing a product. IN NO EVENT WILL WE BE RESPONSIBLE FOR ANY INDIRECT,
SPECIAL, CONSEQUENTIAL OR PUNITIVE DAMAGES.
4.
Assumption of Risk. You acknowledge and agree that any use of the product for any
purpose other than the specified use(s) stated in the product instructions is at Your own risk.
5.
Governing Law. This Warranty gives You specific legal rights, and You also may have
other rights which vary from state to state. This Warranty is governed by the laws of the
State of Michigan, without regard to rules pertaining to conflicts of law. The state courts
located in Oakland County, Michigan shall have exclusive jurisdiction for any disputes
relating to this Warranty.
Rev 9/2014
Sheet 1 of 18
Scan for safe
towing tip, or visit
http://www.ceque
ntgroup.com/qr-
product.aspx
76076NP
6-15-16
Rev. A

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Cequent Performance Products 76076

  • Página 1 TechnicalSupport@cequentgroup.com product.aspx LIMITED LIFETIME WARRANTY Limited Lifetime Warranty (“Warranty”). Cequent Performance Products, Inc. ("We", “Us” or “Our”) warrants to the original consumer purchaser only ("You" or “Your”) that the To prevent SERIOUS INJURY, DEATH or PROPERTY DAMAGE: product will be free from material defects in both material and workmanship, ordinary wear •...
  • Página 2: Installation Instructions

    ™ Cequent Performance Products, Inc. Installation Instructions www.cequentgroup.com PART NUMBERS: 76076, 84076, 800-632-3290 Technical Assistance: TechnicalSupport@cequentgroup.com CQT76076 Applications: Installation Time: 60 min. Years Make Models The time listed above is the average time for professional installers. If you do not...
  • Página 3 Always wear SAFETY GLASSES Installation Instructions when installing hitch PART NUMBERS: 76076, 84076, CQT76076 End panel Re-use existing Bolts Bumper Beam Figure 1 Figure 2 Figure 3 Remove bumper fascia and bumper beam. Remove screws using T25 Torx bit – Remove (4) screws exposed at wheel well liner. Pull back wheel liner to expose an additional (1) screw for removal. Remove (2) screws from the bottom of each wheel well liner.
  • Página 4 Remove screws using T25 Torx bit – Remove (4) screws exposed at wheel well liner. Pull Remove (2) screws from the bottom of each wheel well liner. Remove (4) screws from back wheel liner to expose an additional (1) screw for removal. the middle underside area of the fascia.
  • Página 5 Remove the bumper beam by removing (4) bolts each side with an 18mm socket. Raise hitch and bumper beam into position aligning holes with weldnuts in the vehicle end panel. Sandwich the hitch between the bumper beam and the end panel. Re-use existing bolts.
  • Página 6 Trim fascia as shown in Figure 3. Reinstall fascia in reverse order of steps 1-3. Once bumper fascia is in place, re-attach the sensor antenna wire. ©2016 Cequent™ Performance Products, Inc. - Printed in Mexico Sheet 6 of 18 76076NP 6-15-16 Rev.
  • Página 7: Garantie À Vie Limitée

    GARANTIE À VIE LIMITÉE Garantie à vie limitée (« Garantie »). Cequent Performance Products, Inc. (« Nous », « Notre ») garantit à l’acheteur initial seulement (« Vous », « Votre ») que le produit sera Pour prévenir les blessures SÉVÈRES, FATALES ou les DOMMAGES exempt de vices de matières et de fabrication, exception faite de l’usure normale.
  • Página 8: Équipement Requis

    Cequent ™ Performance Products, Inc. Instructions d’installation www.cequentgroup.com NUMÉROS DE PIÈCES : 76076, 84076, 800-632-3290 Assistance technique : CQT76076 TechnicalSupport@cequentgroup.com Applications : Durée de l'installation : 60 min. Années Marque Modèles La valeur indiquée ci-dessus est la durée moyenne des installeurs professionnels.
  • Página 9 Toujours porter des LUNETTES Instructions d’installation DE PROTECTION lors de l'installation de l'attelage. NUMÉROS DE PIÈCE : 76076, 84076, CQT76076 Panneau d'extrémité Réutiliser les boulons existants Poutre de pare-chocs Figure 1 Figure 2 Figure 3 Enlever le carénage de pare-chocs et la poutre de pare-chocs.
  • Página 10 Retirer les vis à l'aide d'un embout Torx T25 – Retirer quatre (4) vis exposées de la Retirer deux (2) vis dans le bas de la doublure de passage de roue. Retirer quatre (4) vis doublure de passage de roue. Repousser la doublure pour exposer une (1) vis dans la partie centrale du dessous du carénage.
  • Página 11 Soulever l'attelage et la poutre de pare-chocs en position en alignant les trous sur les Enlever la poutre de pare-chocs en retirant quatre (4) boulons de chaque côté à l'aide écrous soudés du panneau d'extrémité du véhicule. Intercaler l'attelage entre la poutre d'une douille 18 mm.
  • Página 12 Découper le carénage selon la Figure 3. Réinstaller le carénage dans l'ordre inverse des étapes 1 à 3. Une fois le carénage de pare-chocs en place, rattacher le fil d'antenne du capteur. ©2016 Cequent™ Performance Products, Inc. - Imprimé au Mexique Feuille 12 de 18 76076NP 6-15-16...
  • Página 13: Garantía Limitada De Por Vida

    CQT76076 GARANTÍA LIMITADA DE POR VIDA Garantía limitada de por vida ("Garantía") Cequent Performance Products, Inc. ("nosotros", Para evitar DAÑOS DE GRAVEDAD, A LA PROPIEDAD O LA MUERTE: "nos" o "nuestro/a/s") garantiza al comprador original únicamente ("usted" o "su/s") que el producto estará...
  • Página 14: Aplicaciones

    ™ Cequent Performance Products, Inc. Instrucciones de instalación www.cequentgroup.com Asistencia técnica: 800-632-3290 NÚMEROS DE PARTES: 76076, 84076, TechnicalSupport@cequentgroup.com CQT76076 Aplicaciones: Tiempo de instalación: 45 min. Años Marca Modelos El tiempo indicado anteriormente es el tiempo promedio para instaladores 2017-Current* Audi profesionales.
  • Página 15 Siempre usar GAFAS DE SEGURIDAD Instrucciones de instalación al instalar el enganche NÚMEROS DE PARTE: 76076, 84076, CQT76076 Panel lateral Volver a usar los pernos existentes Travesaño del Figura 1 Figura 2 Figura 3 parachoques Retirar la fascia del parachoques y el travesaño del parachoques.
  • Página 16 Quitar los tornillos usando brocas Torx T25. Quitar (4) tornillos expuestos en el Retirar (2) tornillos de la parte inferior de cada revestimiento del receptáculo de la revestimiento del receptáculo de la rueda. Tirar hacia atrás el revestimiento de la rueda rueda.
  • Página 17 Retirar el travesaño del parachoques mediante la eliminación de (4) pernos de cada Levantar el enganche y el travesaño del parachoques a su posición al alinear los lado con un llave de 18 mm. orificios con las tuercas de soldar en el panel lateral. Colocar el enganche en el medio entre el travesaño del parachoques y el panel lateral.
  • Página 18 Recortar la fascia como se muestra en la Figura 3. Volver a instalar la fascia en el orden inverso de los pasos 1-3. Una vez que la fascia del parachoques esté en su lugar, volver a instalar el cable de la antena del sensor.

Este manual también es adecuado para:

84076Cqt76076

Tabla de contenido